Specifications

Chapter 2 Product Overview
ReadyBox Users Guide 9
Table 2-2 describes the connector, control, or indicator openings in the I/O panel provided with the
ReadyBoard SBC, and shown in Figure 2-3.
Table 2-2. Connectors or Control/Indicator I/O Panel Openings
Access Opening Description
Power-On LED This power-on indicator is provided on the ReadyBoard.
HDD Activity LED
This IDE activity indicator shows when there is I/O activity for the IDE hard
drive or CompactFlash card and is provided on the ReadyBoard.
Reset Switch
This reset switch is provided on the ReadyBoard. Pressing the Reset switch
supplies a ground signal on the reset line causing a hard reset.
Keyboard/Mouse This 6-pin single PS/2 Keyboard/Mouse connector is provided on the
ReadyBoard. It requires a dual PS/2 output cable provided in the ReadyBoard
SBC QuickStart kit.
USB 0 & 1 These two 4-pin USB type A connectors are provided on the ReadyBoard.
LAN 1 (Ethernet 1) This 8-pin RJ45 connector is provided on the ReadyBoard.
LAN 2 (Ethernet 2) This 8-pin or 10-pin RJ45 connector is provided on the ReadyBoard.
Video (CRT VGA) This 15-pin DB15 connector is provided on the ReadyBoard.
COM 1 & COM 2
(Serial 1 & Serial 2)
These two 9-pin DB9 connectors are provided on the ReadyBoard.
CompactFlash
socket
The CompactFlash socket (not shown) is provided on the underside of the
ReadyBoard and accepts the CompactFlash card through the opening in the
I/O panel of the ReadyBox, if installed.
Power/IDE LED Definitions
Table 2-3 provides the LED colors and definitions for the Power On and IDE drive activity LEDs.
See Figure 2-3. Refer to the specific ReadyBoard SBCfor the Ethernet LED activity.
Table 2-3. Power/IDE Activity LED Indicators
LED# On Off
Power On LED Steady Green = Power On Steady Off = Power Off
IDE Activity LED
Flashing Yellow = IDE activity
(2 ½” IDE drive or CompactFlash)
Steady Off = No IDE activity
Specifications
Environmental Specifications
Table 2-4 provides the most efficient operating and storage condition ranges required for the
ReadyBoard SBC installed into the ReadyBox.
Table 2-4. Environmental Requirements
Parameter Conditions
Temperature
Operating
+0°to+50°C (32°to+122°F)
Storage
–20°to+75°C (–4°to+167°F)
Humidity
Operating 5% to 95% relative humidity, non-condensing
Non-operating 5% to 95% relative humidity, non-condensing