User`s manual

DIGITAL-LOGIC AG MSLB-P5 Manual V0.3
PRELIMINARY 150
*Failing Bits: nnnn
The hex number nnnn is a map of the bits at the RAM address which failed the memory test. Each 1 (one) in the map indicates
a failed bit. See errors 230, 231, or 232 above for offset address of the failure in System, Extended, or Shadow memory.
Fixed Disk n
Fixed disk n (0-3) identified.
Invalid System Configuration Data
Problem with NVRAM (CMOS) data.
I/O device IRQ conflict
I/O device IRQ conflict error.
PS/2 Mouse Boot Summary Screen:
PS/2 Mouse installed.
nnnn kB Extended RAM Passed
Where nnnn is the amount of RAM in kilobytes successfully tested.
nnnn Cache SRAM Passed
Where nnnn is the amount of system cache in kilobytes successfully tested.
nnnn kB Shadow RAM Passed
Where nnnn is the amount of shadow RAM in kilobytes successfully tested.
nnnn kB System RAM Passed
Where nnnn is the amount of system RAM in kilobytes successfully tested.
One or more I2O Block Storage Devices were excluded from the Setup Boot Menu
There was not enough room in the IPL table to display all installed I
2
O block-storage devices.
Operating system not found
Operating system cannot be located on either drive A: or drive C:. Enter Setup and see if fixed disk and drive A: are properly
identified.
*Parity Check 1 nnnn
Parity error found in the system bus. BIOS attempts to locate the address and display it on the screen. If it cannot locate the
address, it displays ????. Parity is a method for checking errors in binary data. A parity error indicates that some data has
been corrupted.
*Parity Check 2 nnnn
Parity error found in the I/O bus. BIOS attempts to locate the address and display it on the screen. If it cannot locate the ad-
dress, it displays ????.
Press <F1> to resume, <F2> to Setup,
<F3> for previous
Displayed after any recoverable error message. Press <F1> to start the boot process or <F2>Fehler! Verweisquelle
konnte nicht gefunden werden. to enter Setup and
14.5 Phoenix Phlash Tool
Phoenix Boot Utilities are:
+ Phoenix QuietBoot™
+ Phoenix MultiBoot™
Phoenix QuietBoot displays a graphic illustration rather than the traditional POST messages while
keeping you informed of diagnostic problems.
Phoenix MultiBoot is a boot screen that displays a selection of boot devices from which you can boot
your operating system.
14.6 Phoenix QuietBoot
Right after you turn on or reset the computer, Phoenix QuietBoot displays the QuietBoot Screen, a
graphic illustration created by the computer manufacturer instead of the text-based POST screen,
which displays a number of PC diagnostic messages.
To exit the QuietBoot screen and run Setup, display the MultiBoot menu, or simply display the PC di-
agnostic messages, you can simply press one of the hot keys described below.
The QuietBoot Screen stays up until just before the operating system loads unless:
You press <Esc> to display the POST screen.
You press <F2> to enter Setup.
POST issues an error message.
The BIOS or an option ROM requests keyboard input.
The following explains each of these situations.