User`s manual

DIGITAL-LOGIC AG MSLB-P5 Manual V0.3
PRELIMINARY 148
Load Setup Defaults
To display the default values for all the Setup menus, select "Load Setup Defaults"
from the Main Menu. The program displays this message:
ROM Default values have been loaded!
Press <space> to continue
If, during bootup, the BIOS program detects a problem in the integrity of values stored
in CMOS, it displays these messages:
System CMOS checksum bad - run SETUP
Press <F1> to resume, <F2> to Setup
The CMOS values have been corrupted or modified incorrectly, perhaps by an appli-
cation program that changes data stored in CMOS.
Press <F1> to resume the boot or <F2> to run Setup with the ROM default values al-
ready loaded into the menus. You can make other changes before saving the values
to CMOS.
Discard Changes
If, during a Setup Session, you change your mind about changes you have made and
have not yet saved the values to CMOS, you can restore the values you previously
saved to CMOS.
Selecting “Discard Changes” on the Exit menu updates all the selections and displays
this message:
CMOS values have been loaded!
Press <space> to continue
Save Changes
Selecting “Save Changes” saves all the selections without exiting Setup. You can re-
turn to the other menus if you want to review and change your selections.