User`s manual

DIGITAL-LOGIC AG MSLB-P5 Manual V0.3
PRELIMINARY 117
6.3 The Harddisk Cable 44 pins
IDT Terminal for Dual Row (2.00 mm grid) and 1.00 mm flat cable. 44 pins = 40 pins signal and 4 pins
power.
1 2
43 44
1 2
43 44
Pin spacing = 1mm
2mm
pin spacing
44 x
Max. length for the IDE cable is 30 cm.
ATTENTION:
Check the pin 1 marker of the cable and the connector before you power-on. See the technical manual
of the drives used, because a wrong cable will immediately destroy the drive and/or the
MICROSPACE PCC-P5L board. There is no warranty in this case. Without the technical manual you
cannot connect this type of drive.
The 44 pins IDE connector on the drives are normally composed of the 44 pins and 2 open pins and 4
test pins, total: 50 pins. Leave the 4 test pins unconnected .
1 3 43a b
c d
Testpin
open pin
44pin IDE Interface with integrated power lines