Specifications

CoreModule 420 Reference Manual 61
Appendix B Connector Part Numbers
Table B-1 provides the non-standard RoHS connectors, including the manufacturers and part numbers,
used on the CoreModule 420. These part numbers can be used to determine the mating connectors,
when making your own cables.
Table B-1. Connector and Manufacture’s Part Numbers
Connector
Pin Number/Pin Spacing/
Orientation
Manufacturer Manufacturer’s PN
J2 – Ethernet 8-pin, 0.1", right angle AMP/Tyco 3-647079-8
J3 – Serial 1,
J5 – Utility,
J7 – Power,
J9 – Serial 2
10-pin, 0.1", right angle TEKA ZR205A1CC-NS-00
ZR205A1BC-NS-00
J4 – Floppy/
Parallel
26-pin, 0.1", right angle TEKA ZR213A1BC-NS-00
ZR213A1CC-NS-00
J6 – IDE 44-pin, 2 mm, straight TEKA HM222CB1N-191-00
HM222CC1N-191-00
J8 – GPIO, 10-pin, 2 mm, straight TEKA HM205CB1N-191-00
HM205CC1N-191-00
J10 – USB 5-pin, 0.140", right angle Tyco 3-641216-5
J11 – Video 44-pin, 2 mm, right angle Adam Tech or
Samtec
2PH2R44SGAHT
TMM-122-01-SM-D-RA
J13 – Serial 3,
J14 – Serial 4
10-pin, 0.1", straight Molex 15-91-3100
Note: The following list provides the Manufacturer abbreviations used in this table and the web sites
where you can locate the required mating connector information.
• Adam Tech = Adam Technologies at http://www.adam-tech.com
• Samtec = Samtec, Inc. at http://www.samtec.com
• Molex = Molex Inc. at http://www.molex.com
• TEKA = Teka Interconnection Systems at http://www.tekais.com
• Tyco = Tyco Electronics Corp at http://www.tycoelectronics.com