Service manual

MDS E-SCAN MPR E-SCAN OPERATION/CALIBRATION

Selecting the “Temp.” option from the calibration menu results in the following display:

(Circulation bath with temperature adjustment and pump is needed for temperature

compensation.) (Not normally used on the MDS-E-Scan system.)

This is the temperature

compensation table. The

“VALUE” column represents the

compensation values, and the

“DEG. C” column represents the

temperatures at which those

compensations occurred.

Using the Front Panel buttons,

both columns of data can be

edited and saved. Since these

values are generated by an actual

temperature run, any changes

made should be done with

extreme caution!

Note: To save sample compensation enter Password

“0000”.

Calibration Temperature Screen