Instruction manual

AMPDIO DRIVERS
Page 25
1. Go to the Control Panel by pressing START > Settings > Control Panel.
2. Double click on the ‘Add/Remove Hardware’
icon. Press ‘Next’.
3. Select ‘Add/Troubleshoot a device’. Press ‘Next’.
4. Windows will search for Plug and Play hardware.
Assuming it finds none, it will present a list of
installed devices. Select ‘Add a new device’.
Press ‘Next’.
5. To the question ‘Do you want Windows to search
for your new hardware?’ select ‘No’ then press
‘Next’.
6. Select the ‘Amplicon Analogue Digital IO Counter
Timer Cards’ hardware type if it exists, otherwise
select the ‘Other devices’ type. Then press
‘Next’.
7. Press ‘Have Disk’, browse to the AMPDIO
software installation directory or the root
directory of the CD-ROM, select the
AMPDIO.INF file (or AMPDIOV4.INF for versions
prior to v5.00), press ‘Open’, then press ‘OK’.
8. Select the card type you have just installed from
the list, then press ‘Next’.
9. On the pop-up dialog which says ‘Windows could
not detect the settings of this device’, press ‘OK’.
10. On the page listing the resources (Input/Output
Range and Interrupt Request), press ‘OK’.
11. On the ‘Start Hardware Installation’ page, press
‘Next’.
12. On the ‘Completing the Add/Remove Hardware
Wizard’ page, press the ‘Resources’ button.
13. If the settings match the base address and IRQ set on the card’s DIP switches and jumpers,
then press ‘OK’, then ‘Finish’, then on the pop-up dialog press ‘Yes’ to allow Windows to
reboot. If the settings do not match then carry on with the following:-
14. In the ‘Settings based on’ drop-down list, select ‘Basic
Configuration 0001’ (or select ‘Basic Configuration 0002’
if the card’s IRQ jumper has been removed).
15. In the ‘Resource settings’ list, select the resource you
wish to change, press the ‘Change Setting’ button,
correct the value using the up and down buttons and
press ‘OK’. Repeat for the other resources you wish to
change.
16. When you are happy with the new resource settings,
press ‘OK’, then ‘Finish’, then on the pop-up dialog press
‘Yes’ to allow Windows to reboot.