Instruction manual

AMPDIO DRIVERS
Page 237
IOCTL_SET_HWADCDIFFMODE Set hardware ADC single-ended/ differential
settings for channels within an ADC channel
group. (Version 4.10 onwards.)
IOCTL_SET_HWADCCHANGAIN Set hardware gain settings for channels within
an ADC channel group. (Version 4.10 onwards.)
IOCTL_SET_HWDACCHANRANGE Set hardware output range settings for channels
within a DAC channel group. (Version 4.20
onwards.)
IOCTL_SET_ADCCONVSRCE Set conversion trigger source for an ADC
channel group. (Version 4.02 onwards.)
IOCTL_SET_ADCMUX Select multiplexed channel for an ADC channel
group. (Version 4.02 onwards.)
IOCTL_START_ADCCONV Provides a software trigger for an A-to-D
conversion for an ADC channel group. (Version
4.02 onwards.)
IOCTL_GET_ADC Reads and cooks data from the data port of an
ADC channel group. (Version 4.02 onwards.)
IOCTL_SET_ADCSTARTACQTRIG Sets ADC start acquisition trigger for an ADC
channel group. (Version 4.42 onwards.)
IOCTL_GET_ADCSTARTACQ-
TRIGGERED
Determines whether start acquisition trigger has
occurred for an ADC channel group, and the
count of samples stored before the trigger
occurred. (Version 4.42 onwards.)
IOCTL_SET_DACCHANS Writes a set of cooked data values to a
corresponding set of channels within a DAC
channel group. (Version 4.02 onwards.)
IOCTL_SET_DACCONVSRCE Set conversion trigger source for a DAC channel
group in FIFO mode. (Version 4.20 onwards.)
IOCTL_SET_DACFIFOWAVE Set DAC FIFO wrap-around mode waveform.
(Version 4.20 onwards.)
IOCTL_START_DACCONV Trigger a DAC conversion in FIFO mode.
IOCTL_ENABLE_IRQEVENT Enable an interrupt source and configure which
data to fetch or write during the interrupt service.
IOCTL_DISABLE_IRQEVENT Disable an interrupt source.
IOCTL_GET_INTSTATUS Read interrupt status port.
IOCTL_WAIT_INTEVENT Wait for an interrupt event to occur.
IOCTL_WAIT_INTEVENT_0 Waits for interrupt event 0 to occur. (Version
4.02 onwards.)
IOCTL_WAIT_INTEVENT_1 Waits for interrupt event 1 to occur. (Version
4.02 onwards.)