7 PowerTel 701 Extender User Guide SERIES
C ONTENTS Important Safety Instructions ...........................................4 Cordless Handset and Charger Base Cordless Phone Handset Display Icons .......................................6 ..............................7 Getting Started/Setup .................................................................8 Adding a Handset .......................................................................10 Help and Support ........................................................................
FCC COMPLIANCE FCC Compliance The FCC requires that you will be advised of certain requirements involving the use of this telephone. 1. This equipment complies with Part 68 of the FCC rules. A label on the base unit of this equipment contains, among other information, the ACTA Registration Number (US:AAAEQ##TXXXX) and the Ringer Equivalence Number (REN) for this equipment. You must, upon request, provide this information to your telephone company. terminal equipment. 3.
Safety Important Safety Instructions When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1..Do not use this product near water, for example, near a bath tub, wash bowl, kitchen sink or laundry tub, in a wet basement or near a swimming pool. 2..Do not use the telephone to report a gas leak in the vicinity of the leak. 3.
S A FETY • • • Where it is not obstructed by furniture At least three feet from other electrical appliances Away from smoke, dust, vibration, chemicals, moisture, heat or direct sunlight. Power failure – What to do Power failure can affect your phone and equipment. Only the corded phone will work if there is a power failure. Medical equipment Do not use the phone near emergency or intensive care medical equipment, or during an electrical storm.
handset and CharGer Base PowerTel 701 Cordless Handset and Charger Base 1 M 13 s 2 25 rTel 7 Ser we ie Po M M 11 3 12 22 14 23 4 5 6 15 REDIAL MENU INT FLASH TONE CID 7 8 9 10 1 Incoming call 14 Up/Redial 2 Memory 1 15 Headset socket 3 Boost 4 Display 5 Enter Menu/Mute/ Delete 16 6 Internal call 17 7 External call/ 18 Handsfree 19 20 LOCK 8 /Ringer on/off 9 Pause (long press 0) 10 Microphone 21 11 Memory 3 12 Volume up/down 13 Memory 2 24 6 (Headset not included) 16
H ANDSET D ISPLAY I CONS Cordless Phone Handset Display Icons The following icons can appear in the LCD display: Phone book mode Play messages fast forward More information to view up Boost receiver volume is on More information to view down Battery status Mute handset microphone Ringer off New calls Keylock is on Answering machine is on Handsfree mode Answering machine is off Call in progress When steady— handset is in range Internal call in progress (if additional handsets are range insta
Getting started Getting Started — Included Equipment PowerTel 701 Extender - Amplified Cordless Accessory Handset • 1 cordless Handset • 1 Rechargable Battery Pack & 3 AAA 3.6V NiMH • 1 charger base for cordless Handset( with Power Adapter Plug Attached) Set up 1. Connect cordless phone charger base Plug the power adapter from the charger base into a wall socket.
GettinG started Set Up - continued 1. Install the battery pack Insert the rechargeable battery pack into the handset as shown. Dispose of battery pack properly. Do not allow battery pack to come into contact with fire or water. 2.Charge the handset Place the handset on its base to charge for a minimum of 16 hours before use. Important: make sure any handset is fully charged before registering.
G ETTING STARTED Registration key guide PAGE PAGE PowerTel 700 PowerTel 720 PAGE Press and hold registration key PAGE for at least 10 seconds PowerTel 760 10 Service Center
addinG a handset PowerTel 701 Cordless handset and charger base Adding a Handset – Cordless Phone Only register a handset if it has become de-registered from the base or if it was purchased separately. At the handset: 1. Press and hold MENU for approx 10 seconds until the display shows Press and hold Page key. At the base: 2. Press and hold PAGE for at least 10 seconds until the display shows Register.
help and support Help and Support Some issues may simply be resolved by disconnecting the power to the unit. In such instances the power to the main base station should be switched off and battery pack in the handset should also be removed for about 20 minutes. After 20 minutes, replace the battery pack and reconnect everything to determine if this has resolved the issue. Troubleshooting Guide I can’t make phone calls 1. Make sure the phone cable is connected properly.
Help and support My handset keeps switching off 1. It may need recharging. So it can charge fully, place your handset on its charger base for at least 16 hours with the charger base plugged in and working. 2. Replace the rechargeable battery pack. Any replacement battery packs should be the same type as those provided. The phone system isn’t responding You may need to reset to default settings. Caller’s identification (Call Line ID) isn’t working 1. Check you have this service on your phone line.
General information Energy efficient power adapter The included power adapter meets the eco-design requirements of the European Union (Directive 2005/32/EG). Disposal The symbol on this product indicates that electrical and electronic apparatus and battery pack must be disposed of separately from domestic waste at suitable collection points provided by the public waste authorities. Technical Details DECT¹ GAP² Input: 100-240V ~50/60Hz 0.
General information Default Settings Cordless handset Language Handset name Handset ringing melody (external) Handset ringing melody (internal) Handset ringing volume Base ringing melody Base ringing volume Keypad beep Auto talk Contrast Backlight time Boost memory Recall time Dialing mode PIN code Telephone answering machine Language Answer mode PIN code for remote access Answer delay Time format 1-866-AMPLICOM (267-5426) English PowerTel 7 9 5 8 5 On On 3 10s Off 600ms Tone 0000 English Answer and re
General information Maintenance and Warranty Maintenance • • Please clean your equipment’s surfaces with a soft, lint-free cloth. Never use cleaning agents or solvents. Warranty AMPLICOM equipment is produced and tested according to the latest production methods. The implementation of carefully chosen materials and highly developed technologies ensure trouble free functioning and a long service life.
General information our property. Rights to compensation in the case of damage are excluded where there is no evidence of intent or gross negligence by the manufacturer. If your equipment shows signs of defect during the period of warranty, please return to the sales outlet in which you purchased the AMPLICOM equipment together with the purchase receipt. All rights to claims under the terms of warranty in accordance with this agreement must be asserted exclusively with regard to your sales outlet.
This page intentionally left blank.
