Brochure

TEL: [phone] FAX: [phone] NA TOLL FREE 1-866-816-6540 E-MAIL: [e-mail]
8
P E R F O R M A N C E D A T A
Contact Rating --- 3 amps max.
Magnetic Permeability ASTM-A342/A342M 2.0 µ max.
D.W.V. EIA-364-20 at sea level: 600 vac for solder pot and standard wire
(Test voltage rms 60 Hz ac volts) at 70,000 ft altitude (reduced barometric pressure):
150 vac for solder pot and standard wire
Insulation Resistance EIA-364-21 5000 megohms min.
Contact Resistance EIA-364-23 8 milliohms at 3 amps
Contact Engagement Force MIL-DTL-83513 6.0 oz. max.
Contact Separation Force MIL-DTL-83513 0.5 oz. min.
Connector Mating Force MIL-DTL-83513 (10 oz. times no. of contacts) max.
Connector Unmating Force MIL-DTL-83513 (0.5 oz. times no. of contacts) min.
Thermal Shock EIA-364-32, condition I, 5 cycles No physical damage
(Temperature Cycling)
-55°C to +125°C (-67°F to +257°F)
Mechanical Shock EIA-364-27, condition E No physical damage and no loosening of parts
(Specified Pulse)
No loss of continuity > 1 microsec.
Vibration EIA-364-28, condition IV No physical damage and no loosening of parts
No loss of continuity > 1 microsec.
Durability MIL-DTL-83513 500 mating cycles at a rate of 200 ±100 CPH
Salt Spray
(Corrosion) EIA-364-26, condition B Meets mateability and contact resistance requirements
Fluid Immersion MIL-DTL-83513 Meets mateability requirements
Humidity EIA-364-31 Meets D.W.V. and insulation resistance requirements
1 megohm min. after step 6, 1000 megohms min.
after 24 hrs of conditioning
Insert Retention
(class M) MIL-DTL-83513 50 lbs psi (axial load)
Solderability MIL-STD-202, method 208 Withstand test condition
Contact Retention E IA-364-29 5 lbs min. (axial load)
Thermal Vacuum Outgassing SP-R-0022 or ASTM E595 Exceeds MIL-DTL-83513 requirements; standard is 1.0%
(Space Classes)
max TML and 0.1% max VCM of original mass
Test Description Specification/ Method * Limits
* Standards References
MIL = Department of Defense
ASTM = ASTM International
EIA = Electronic Industries Association
SP = NASA
** Does not apply for die-cast parts (consult factory before ordering)
MICROMINATURE CONNECTOR
PERFORMANCE DATA
The following data applies to a standard Amphenol
Canada micro-d connector that is in accordance
with M83513 spec.
Variations from standard products may cause
performance to vary from that mentioned below.
Consult factory for special applications
and requirements.
Amphenol
®
Canada