Specifications

ManualsBrandsAmpex ManualsMusical equipment230 plus

P/N

3515042-01

INSERT

CHANGING KEYBOARD CHARACTER

SET

Removing

Keycaps

When

installing

one of the

optional national character sets, remove

and

replace keycaps

properly,

using

the

keycap remover provided

by

Ampex (Part

No.

074-297)

or use an

equivalent device (Figure

lns-1).

For

proper removal

of

keycaps, follow this procedure:

1.

Turn

the

power

"off"

and

disconnect

the

keyboard from

the

terminal.

2.

Using

the

Keycap Remover (Figure

lns-1),

gently place

the

tongs under

the

keycap.

3.

Twist

the

Keycap Remover

forty-five

degrees

to the

right

so

that

the

handle

is

pointing

diagonally.

4.

Carefully lift

up on the

keycap

until

it

snaps

out of

place.

5.

Remove

the

keycap from

the

tongs. Make sure that

the

yellow plunger

is

still

in

place

on the

keyboard (see Figure

lns-2).

If the

yellow plunger

was

removed with

the

keycap, follow

the

procedure below

to

re-insert

the

plunger.

Figure

lns-1.

Keycap Remover

lnsert-1