User Guide

D-10 Ampex 1308911-02
Model No.
Running Head
Latched/Continuous Status Field MSR Diagnostic Status Information
158 2 Transport Fault: Coupling Servo Crash - Set when coupling servo
error becomes excessive.
158 1 Transport Fault: EOT Sensor Failed - Set when end-of-tape sensor
has failed.
158 0 Transport Fault: Scanner Not Locked - Set when scanner phase is
out of sync with reference signals.
159 7 Transport Fault: Scanner Current High - Set when scanner motor
current is excessive.
159 6 Transport Fault: Scanner Tach Absent - Set when scanner should be
rotating but no tachometer pulses are sensed.
159 5 Transport Fault: Supply Arm Misaligned - Set when supply arm
needs major mechanical and/or electrical adjustment.
159 4 Transport Fault: Supply Arm Out of Tolerance - Set when supply arm
needs minor mechanical and/or electrical adjustment.
159 3 Transport Fault: Supply Arm Torque Fault - Set when supply arm
servo develops insufficient or excessive torque for proper arm
movement.
159 2 Transport Fault: Supply Arm Current High - Set when excessive
supply arm motor current is needed for arm movement.
159 1 Transport Fault: Supply Reel Jammed - Set when supply reel should
be rotating but no movement is sensed.
159 0 Transport Fault: Supply Reel Tach Absent - Set when no supply reel
motor tachometer pulses are sensed.
160 7 Transport Fault: Supply Reel Current High - Set when supply reel
motor current is excessive.
160 6 Transport Fault: Supply Reel Servo Failure - Set when supply reel
servo cannot maintain proper supply reel movement/operation.
160 5 Transport Fault: Supply Arm Position Fault - Set when nominal
supply arm position is not maintained by supply side servo.
160 4 Transport Fault: Takeup Arm Misaligned - Set when takeup arm
needs major mechanical and/or electrical adjustment.
160 3 Transport Fault: Takeup Arm Out of Tolerance - Set when takeup
arm needs minor mechanical and/or electrical adjustment.
160 2 Transport Fault: Takeup Arm Torque Fault - Set when takeup arm
servo develops insufficient or excessive torque for proper arm
movement.
Table D-2. Latched/Continuous Status Parameters (Continued)
Byte Bit Description