User Guide

Ampex 1308911-02 C-7
Result Codes and Machine Status Introduction
21 DstCodeInvParmFld, Invalid field in received parameter list
22 DstCodeWriteProt, Cartridge is write-protected
23 DstCodeN2RTrans, Transition from not-ready to ready occurred
24 DstCodeReset, Power-on, reset, or bus device reset occurred
25 DstCodeParmChanged, Mode parameters have changed
26 DstCodeLogParmChg, Log parameters have changed
27 DstCodeCmdSeqErr, Command sequence error (received in wrong order)
28 DstCodeBadMedType, Cartridge not supported based on coding holes
29 DstCodeUnknownFmt, Unknown tape format
30 DstCodeBadMedFmt, Invalid tape format detected
31 DstCodeCleanCart, Cleaning cartridge is in the transport
32 DstCodeCorruptFmt, Medium tape format corrupted
33 DstCodeNoCassette, No cartridge present
34 DstCodeBOMPosErr, BOM encountered unexpectedly
35 DstCodeEOMPosErr, EOM encountered unexpectedly
36 DstCodeReposErr, Positioning failed during retries
37 DstCodeLUNNotConf, Logical unit not self-configured yet
38 DstCodeInqDataChg, Inquiry data has changed
39 DstCodeIntTargFail, Internal target fatal error
40 DstCodeEnvErr, Environmental error (internal target failure)
41 DstCodeBadBlockWr, Bad block written
42 DstCodeCmdPhaseErr, Command phase error
43 DstCodeDatPhaseErr, Data phase error
44 DstCodeOverlapCmd, Overlapped commands attempted
45 DstCodeWrAppend, Write append error
46 DstCodeNoRemove, Cartridge is prevented from removal
47 DstCodeThreshMet, Threshold condition met
48 DstCodeVolOvr, Volume overflow - EOM detected on write
49 DstCodeInvalidArg, Invalid argument provided by the user
50 DstCodeNoPermission, No permission to perform requested task
51 DstCodeLoadError, Error while loading tape
52 DstCodeRewindError, Error while rewinding tape
Table C-3. Tape Drive Result Codes (Continued)
Code Enumeration Description