User Guide

5-28 Ampex 1308910-01
Model No.
Running Head
acl_move_volume ACL Application Programmer’s Guide
-barcode < barcode>
The barcode ID of the tape cartridge that you want to move. This value must be six decimal
digits. If you specify less than six digits, the barcode is proceeded by zeros.
-to <
destination_location>
Specifies the name or address of the ACL location to which the tape cartridge is to be moved.
ENVIRONMENT
The ACL management utilities use the following environment variable.
$ACL_DEV
Specifies the device special file to use when you omit the -f option.
EXIT STATUS
The ACL management utilities use the following exit status codes:
0 Operation succeeded.
nonzero Operation failed.
See ““Exit Status” on page 5-7” for information on how to determine the cause of a failure.
EXAMPLE
Move tape cartridge 000132 to the drive addressed 100 in the DST 412.
acl_move_volume -barcode 132 -to 100
SEE ALSO
• “ACL Utilities Overview” on page 5-1,
• “acl_move_tape” on page 5-25
• “aclMoveVolume” on page 4-23
• “dst_unload_tape” in the DST/DIS Tape Drive UNIX Programmer’s Guide