User Guide

A-28 Ampex 1308910-01
Model No.
Running Head
CHS Failure, Error, and Warning Codes Returned Sense Data
4018 (0xFB2) Elevator mda was safety shut off
4019 (0xFB3) Elevator upper over travel sensor tripped
4020 (0xFB4) Finished waiting for the tape drive to power down
4021 (0xFB5) Front door is open
4022 (0xFB6) Front door safety switch is open
4023 (0xFB7) Front door safety switch was opened
4024 (0xFB8) In-arm mda safety shut off is disabled
4025 (0xFB9) In-arm mda was safety shut off
4026 (0xFBA) Loader frame is not in position for manual loading
4027 (0xFBB) Manual loaded cartridge failed to exit the load port
4028 (0xFBC) Manual loaded cartridge failed to reach drive home sensor
4029 (0xFBE) Manual loaded cartridge failed to reach the tape drive elevator
4030 (0xFBE) Out-arm mda safety shut off is disabled
4031 (0xFBF) Out-arm mda was safety shut off
4032 (0xFC0) Still waiting for the tape drive to power down
4033 (0xFC1) Tape drive is not ready to accept a cartridge
4034 (0xFC2) Waiting for the tape drive to power down
DIAGNOSTIC MESSAGES (412)
5001 (0x1389) All bins audited to be empty
5002 (0x138A) Arm calibration requires a large cartridge to be in bin # 7
5003 (0x138B) Arm calibration successfully completed
5004 (0x138C) Calibrating the elevator
5005 (0x138D) Calibrating the in-arm
5006 (0x138E) Calibrating the out-arm
5007 (0x138F) Cartridge failed to contact in-arm for an unload
5008 (0x1390) Elevator calibration data write checksum error
5009 (0x1391) Elevator calibration requires bin #1 to be empty
5010 (0x1392) Elevator calibration successfully completed
5011 (0x1393) Elevator must be moved to bin #4 for calibration
Table A-4. CHS Failure, Error, and Warning Codes (Continued)
CHS Code Description