User Guide

Ampex 1308910-01 A-27
Returned Sense Data CHS Failure, Error, and Warning Codes
ERROR MESSAGES (412)
3001 (0xBB9) Cannot load to an occupied drive elevator
3002 (0xBBA) Cannot unload to an occupied elevator bin
3003 (0xBBB) Illegal bin number for a load
3004 (0xBBC) Illegal bin number for a move
3005 (0xBBD) Illegal bin number for an audit
3006 (0xBBE) Illegal bin number for an unload
3007 (0xBBF) Previous command has not completed
3008 (0xBC0) The abort command is not currently supported
3009 (0xBC1) The read command is not currently supported
3010 (0xBC2) The readall command is not currently supported
ATTENTION MESSAGES (412)
4001 (0xFA1) Bin audit procedure has conflicting data
4002 (0xFA2) Cannot enable in-arm servo position mode
4003 (0xFA3) Cannot enable out-arm servo position mode
4004 (0xFA4) Cannot set in-arm position counter
4005 (0xFA5) Cannot set out-arm position counter
4006 (0xFA6) Cartridge failed to contact home switch during re-load
4007 (0xFA7) Cartridge failed to reach final position during re-load
4008 (0xFA8) Drive elevator feed control failed to enable inject sensor
4009 (0xFA9) Drive timeout failed to clear load port sensor
4010 (0xFAA) Drive timeout failed to enable load port sensor
4011 (0xFAB) Drive timeout re-load failed to enable home sensor
4012 (0xFAC) Drive timeout re-load failed to enable load port sensor
4013 (0xFAD) Elevator failed to move down during recovery
4014 (0xFAE) Elevator failed to move up during recovery
4015 (0xFAF) Elevator failed to position during re-load
4016 (0xFB0) Elevator lower over travel sensor tripped
4017 (0xFB1) Elevator mda safety shut off is disabled
Table A-4. CHS Failure, Error, and Warning Codes (Continued)
CHS Code Description