User Guide

Ampex 1308910-01 A-25
Returned Sense Data CHS Failure, Error, and Warning Codes
1105 (0x451) Out-arm failed move to safe during calibration
1106 (0x452) Out-arm failed to clean-up a load failure
1107 (0x453) Out-arm Failed To Enable Position Mode After Calibration
1108 (0x454) Out-arm failed to enable position mode after calibration
1109 (0x455) Out-arm failed to enable position mode during calibration
1110 (0x456) Out-arm failed to find elevator bar for calibration
1111 (0x457) Out-arm failed to move home after audit
1112 (0x458) Out-arm failed to move home after calibration
1113 (0x459) Out-arm failed to move to safe for audit
1114 (0x45A) Out-arm failed to position back out for unload
1115 (0x45B) Out-arm failed to position for in-arm calibration
1116 (0x45C) Out-arm failed to properly move for audit
1117 (0x45D) Out-arm failed to properly move for unload
1118 (0x45E) Out-arm mda fuse [F5] is open
1119 (0x45F) Out-arm mda was safety shut off
1120 (0x460) Out-arm move sequencer timed out
1121 (0x461) Out-arm servo is not ready for auditing
1122 (0x462) Out-arm servo is not ready for loading
1123 (0x463) Out-arm servo is not ready for unloading
1124 (0x464) Out-arm servo not initialized
1125 (0x465) Park control sequencer timed out
1126 (0x466) Servo initialization sequencer timed out
1127 (0x467) Servos are not initialized for a calibration
1128 (0x468) Servos are not ready for an elevator move
1129 (0x469) System calibration sequencer timed out
1130 (0x46A) Tape cartridge is in an unsafe position for auditing
1131 (0x46b) Unload control sequencer timed out
Table A-4. CHS Failure, Error, and Warning Codes (Continued)
CHS Code Description