User Guide

A-24 Ampex 1308910-01
Model No.
Running Head
CHS Failure, Error, and Warning Codes Returned Sense Data
1076 (0x434) In-arm failed to move home after calibration
1077 (0x435) In-arm failed to position out for load
1078 (0x436) In-arm failed to position in for load
1079 (0x437) In-arm failed to properly move in for audit
1080 (0x438) In-arm failed to properly move out for audit
1081 (0x439) In-arm failed to restore after an unload cartridge abort
1082 (0x43A) In-arm failed to restore after unload failure
1083 (0x43B) In-arm mda fuse [F6] is open
1084 (0x43C) In-arm mda was safety shut off
1085 (0x43D) In-arm move sequencer timed out
1086 (0x43E) In-arm servo is not ready for auditing
1087 (0x43F) In-arm servo is not ready for loading
1088 (0x440) In-arm servo is not ready for unloading
1089 (0x441) In-arm failed to return home
1090 (0x442) In-arm servo not initialized
1091 (0x443) Load control sequencer timed out
1092 (0x444) Load port became occupied during an elevator move
1093 (0x445) Load port cannot be occupied during initialization
1094 (0x446) Load port cannot be occupied for calibration
1095 (0x447) Load port is not clear for an elevator move
1096 (0x448) Load port motor voltage out of range
1097 (0x449) Load port sensor does not respond to self test
1098 (0x44A) Loader frame is not in position for loading
1099 (0x44B) Loader frame is not in position for unloading
1100 (0x44C) Loader port roller mda fuse [F3] is open
1101 (0x44D) Middle vane detector failed to indicate
1102 (0x44E) Out-arm calibration data write checksum error
1103 (0x44F) Out-arm cannot find elevator bar for calibration
1104 (0x4501) Out-arm failed move to safe after calibration
Table A-4. CHS Failure, Error, and Warning Codes (Continued)
CHS Code Description