User Guide

Ampex 1308910-01 A-23
Returned Sense Data CHS Failure, Error, and Warning Codes
1047 (0x417) Elevator lower over-travel sensor tripped
1048 (0x418) Elevator mda fuse [F10] is open
1049 (0x419) Elevator mda fuse [F9] is open
1050 (0x41A) Elevator mda was safety shut off
1051 (0x41B) Elevator motor drive failed for initialization
1052 (0x41C) Elevator Motor voltage out of range
1053 (0x41D) Elevator move sequencer timed out
1054 (0x41E) Elevator not configured to unload a large cartridge
1055 (0x41F) Elevator not configured to unload a medium cartridge
1056 (0x420) Elevator not configured to unload a small cartridge
1057 (0x421) Elevator servo failed to position for a move
1058 (0x422) Elevator servo is not ready for auditing
1059 (0x423) Elevator servo is not ready for loading
1060 (0x424) Elevator servo is not ready for parking
1061 (0x452) Elevator servo is not ready for unloading
1062 (0x426) Elevator servo is not initialized
1063 (0x427) Elevator size configuration is unknown
1064 (0x428) Elevator upper over travel limit exceeded
1065 (0x429) Elevator upper over travel sensor tripped
1066 (0x42A) Elevator vane sensor data error
1067 (0x42B) Front door is open
1068 (0x42C) Front door must be closed for calibration
1069 (0x42D) Front door safety switch is open
1070 (0x42E) Front door safety switch was opened
1071 (0x42F) Illegal in-arm parameter
1072 (0x430) In-arm audit move reported an illegal warning
1073 (0x43‘) In-arm calibration data write checksum error
1074 (0x432) In-arm failed to bumper position for unload
1075 (0x433) In-arm failed to enable position mode after calibration
Table A-4. CHS Failure, Error, and Warning Codes (Continued)
CHS Code Description