User Guide

Ampex 1308910-01 A-21
Returned Sense Data CHS Failure, Error, and Warning Codes
715 (0x2CB) Y-axis over speed sensor trip
719 (0x2CF) MDA system reset
720 (0x2D0) Left overtravel sensor trip
721 (0x2D1) Right overtravel sensor trip
722 (0x2D2) Upper overtravel sensor trip
723 (0x2D3) Lower overtravel sensor trip
724 (0x2D4) X-servo did not lock on a goto
725 (0x2D5) Y-servo did not lock on a goto
731 (0x2D8) Z-cass became false on a goto
732 (0x2D9) Z-vane became false on a goto
733 (0x2DA) X&Y servo did not lock on goto
FAILURE MESSAGES (412)
1001 (0x3E9) +15Vdc power is missing
1002 (0x3EA) +24Vdc power is missing
1003 (0x3E) Arms calibration sequencer timed out
1004 (0x3EC) Audit control sequencer timed out
1005 (0x3ED) Calibrate cannot find elevator bottom vane detector
1006 (0x3EE) Cannot enable elevator servo position mode
1007 (0x3EF) Cannot enable in-arm servo position mode
1008 (0x3F0) Cannot enable out-arm servo position mode
1009 (0x3F1) Cannot find a large cartridge in bin #7 for calibration
1010 (0x3F2) Cannot find elevator bottom vane detector
1011 (0x3F3) Cannot find elevator center vane detector
1012 (0x3F4) Cannot preset elevator position counter
1013 (0x3F5) Cannot set in-arm position counter
1014 (0x3F6) Cannot set out-arm position counter
1015 (0x3F7) Cartridge appears to be stuck in load port after unload
1016 (0x3F8) Cartridge caddy door is not closed
1017 (0x3F9) Cartridge Did not enter drive elevator for loading
Table A-4. CHS Failure, Error, and Warning Codes (Continued)
CHS Code Description