User Guide

Ampex 1308910-01 A-13
Returned Sense Data Vendor-Specific ACL Condition Codes
0x05 0x21 0x01 0x33
Illegal Request
AC_SOURCE_ELEM_RANGE, Illegal
Request, Source Element Address
Out of Range
The move command cannot be
completed with the source address
supplied in the SCSI command.
Read Element Status and verify
that the addresses are valid and
the move is permitted.
0x05 0x21 0x01 0x34
Illegal Request
AC_DEST_ELEM_RANGE
Illegal Request, Destination
Element Address Out of Range
The move command cannot be
completed with the destination address
supplied in the SCSI command.
0x05 0x21 0x01 0x35
Illegal Request
AC_TRANS_ELEM_RANGE
Illegal Request, Transport
Element Address Out of Range
The move command cannot be
completed with the transport element
address supplied in the SCSI command.
0x05 0x21 0x01 0x36
Illegal Request
AC_ILLEGAL_MOVE
Illegal Request, Move Not
Permitted
The move you specified is not
permitted.
0x05 0x24 0x00 0x28
Illegal Request
AC_INVALID_CDB_FIELD
Illegal Request, Invalid Field
in SCSI CDB
A field in the SCSI Command
Descriptor Block (CDB) contained an
invalid entry.
An invalid SCSI command was
sent to the ACL by the host
system. Verify that:
• the ACL software and device
driver are installed properly.
• the SCSI host adapter is
functioning correctly.
• the cabling between the host
system and the ACL is not
damaged.
0x05 0x25 0x00 0x01
Illegal Request
AC_LUN_NOT_ZERO
Illegal Request, LUN Not Set to
Zero in SCSI CDB
The Logical Unit Number field in the
SCSI Command Descriptor Block
(CDB) was not zero.
Table A-3. Vendor-Specific ACL Condition Codes (Continued)
ACL
Sense ASC ASCQ Condition
Key Code
Error Enumeration,
String, and Condition
Recovery Procedure