User Guide

Ampex 1308910-01 A-9
Returned Sense Data Vendor-Specific ACL Condition Codes
0x02 0x53 0xAA 0x2A
Not Ready
AC_DRIVE_NOT_READY_TO_LOAD
Not Ready, Tape Drive Unable to
Load Cartridge
(412)
The tape drive in the ACL has an enable
bit that must be set before a cartridge
may be loaded.
Make sure that:
• The drive is on-line and not in
use.
• A cartridge is not loaded in
the drive or present in the
drive load port.
• The drive elevator is up.
0x02 0x55 0xC3 0x43
Not Ready
AC_ROBOT_TXP_ELEVATOR_NOT_UP
Not Ready, Tape Drive Elevator
is Not Up
(812)
The ACL cannot load or unload
cartridges to/from the tape drive
because its elevator is not in the up
position.
0x02 0x53 0xAA 0x47
Hardware Error
AC_DRIVE_OUT_OF_FRAME
The tape drive is pulled out of cabinet.
Push drive into cabinet until it
latches.
0x02 0x5A 0xC0 0x40
Hardware Error
AC_ROBOT_OUT_OF_FRAME
Hardware Error, ACL Cabinet is
Open
(412)
Cartridges cannot be loaded or
unloaded from the tape drive when the
CHS assembly is swung away from the
ACL cabinet.
Close the ACL cabinet.
0x04 0x55 0x00 0x19
Hardware Error
AC_RBT_TALLY_FAILURE
Hardware Error, CHS Tally
Failure
A CHS hardware failure occurred.
A SCSI reset or power reset may
bring the system back. If not,
contact Ampex Technical
Support.
0x04 0x55 0x00 0x25
Hardware Error
AC_LOAD_FAIL
Hardware Error, CHS Could Not
Load Cartridge into Tape Drive
The CHS could not load the tape
cartridge into the tape drive.
Make sure that:
• A cartridge is not loaded in
the drive or present in the
drive load port.
• The drive elevator is up.
Table A-3. Vendor-Specific ACL Condition Codes (Continued)
ACL
Sense ASC ASCQ Condition
Key Code
Error Enumeration,
String, and Condition
Recovery Procedure