User Guide

Ampex 1308904-X4 Preliminary Draft A-25
ACL Application Programmer’s Guide CHS Failure, Error, and Warning Codes
4018d (FB2h) Elevator mda was safety shut off
4019d (FB3h) Elevator upper over travel sensor tripped
4020d (FB4h) Finished waiting for the tape drive to power down
4021d (FB5h) Front door is open
4022d (FB6h) Front door safety switch is open
4023d (FB7h) Front door safety switch was opened
4024d (FB8h) In-arm mda safety shut off is disabled
4025d (FB9h) In-arm mda was safety shut off
4026d (FBAh) Loader frame is not in position for manual loading
4027d (FBBh) Manual loaded cartridge failed to exit the load port
4028d (FBCh) Manual loaded cartridge failed to reach drive home sensor
4029d (FBEh) Manual loaded cartridge failed to reach the tape drive elevator
4030d (FBEh) Out-arm mda safety shut off is disabled
4031d (FBFh) Out-arm mda was safety shut off
4032d (FC0h) Still waiting for the tape drive to power down
4033d (FC1h) Tape drive is not ready to accept a cartridge
4034d (FC2h) Waiting for the tape drive to power down
DIAGNOSTIC MESSAGES (2XX, 4XX)
5001d (1389h) All bins audited to be empty
5002d (138Ah) Arm calibration requires a large cartridge to be in bin # 7
5003d (138Bh) Arm calibration successfully completed
5004d (138Ch) Calibrating the elevator
5005d (138Dh) Calibrating the in-arm
5006d (138Eh) Calibrating the out-arm
5007d (138Fh) Cartridge failed to contact in-arm for an unload
5008d (1390h) Elevator calibration data write checksum error
5009d (1391h) Elevator calibration requires bin #1 to be empty
5010d (1392h) Elevator calibration successfully completed
5011d (1393h) Elevator must be moved to bin #4 for calibration
Table A-5. CHS Failure, Error, and Warning Codes (Continued)
CHS Code Description