User Guide

A-22 Preliminary Draft Ampex 1308904-X4
Model No.
Running Head
CHS Failure, Error, and Warning Codes ACL Application Programmer’s Guide
1105d (451h) Out-arm failed move to safe during calibration
1106d (452h) Out-arm failed to clean-up a load failure
1107d (453h) Out-arm Failed To Enable Position Mode After Calibration
1108d (454h) Out-arm failed to enable position mode after calibration
1109d (455h) Out-arm failed to enable position mode during calibration
1110d (456h) Out-arm failed to find elevator bar for calibration
1111d (457h) Out-arm failed to move home after audit
1112d (458h) Out-arm failed to move home after calibration
1113d (459h) Out-arm failed to move to safe for audit
1114d (45Ah) Out-arm failed to position back out for unload
1115d (45Bh) Out-arm failed to position for in-arm calibration
1116d (45Ch) Out-arm failed to properly move for audit
1117d (45Dh) Out-arm failed to properly move for unload
1118d (45Eh) Out-arm mda fuse [F5] is open
1119d (45Fh) Out-arm mda was safety shut off
1120d (460h) Out-arm move sequencer timed out
1121d (461h) Out-arm servo is not ready for auditing
1122d (462h) Out-arm servo is not ready for loading
1123d (463h) Out-arm servo is not ready for unloading
1124d (464h) Out-arm servo not initialized
1125d (465h) Park control sequencer timed out
1126d (466h) Servo initialization sequencer timed out
1127d (467h) Servos are not initialized for a calibration
1128d (468h) Servos are not ready for an elevator move
1129d (469h) System calibration sequencer timed out
1130d (46Ah) Tape cartridge is in an unsafe position for auditing
1131d (46bh) Unload control sequencer timed out
Table A-5. CHS Failure, Error, and Warning Codes (Continued)
CHS Code Description