User Guide

Ampex 1308904-X4 Preliminary Draft A-21
ACL Application Programmer’s Guide CHS Failure, Error, and Warning Codes
1076d (434h) In-arm failed to move home after calibration
1077d (435h) In-arm failed to position out for load
1078d (436h) In-arm failed to position in for load
1079d (437h) In-arm failed to properly move in for audit
1080d (438h) In-arm failed to properly move out for audit
1081d (439h) In-arm failed to restore after an unload cartridge abort
1082d (43Ah) In-arm failed to restore after unload failure
1083d (43Bh) In-arm mda fuse [F6] is open
1084d (43Ch) In-arm mda was safety shut off
1085d (43Dh) In-arm move sequencer timed out
1086d (43Eh) In-arm servo is not ready for auditing
1087d (43Fh) In-arm servo is not ready for loading
1088d (440h) In-arm servo is not ready for unloading
1089d (441h) In-arm failed to return home
1090d (442h) In-arm servo not initialized
1091d (443h) Load control sequencer timed out
1092d (444h) Load port became occupied during an elevator move
1093d (445h) Load port cannot be occupied during initialization
1094d (446h) Load port cannot be occupied for calibration
1095d (447h) Load port is not clear for an elevator move
1096d (448h) Load port motor voltage out of range
1097d (449h) Load port sensor does not respond to self test
1098d (44Ah) Loader frame is not in position for loading
1099d (44Bh) Loader frame is not in position for unloading
1100d (44Ch) Loader port roller mda fuse [F3] is open
1101d (44Dh) Middle vane detector failed to indicate
1102d (44Eh) Out-arm calibration data write checksum error
1103d (44Fh) Out-arm cannot find elevator bar for calibration
1104d (4501h) Out-arm failed move to safe after calibration
Table A-5. CHS Failure, Error, and Warning Codes (Continued)
CHS Code Description