User Guide

A-20 Preliminary Draft Ampex 1308904-X4
Model No.
Running Head
CHS Failure, Error, and Warning Codes ACL Application Programmer’s Guide
1047d (417h) Elevator lower over-travel sensor tripped
1048d (418h) Elevator mda fuse [F10] is open
1049d (419h) Elevator mda fuse [F9] is open
1050d (41Ah) Elevator mda was safety shut off
1051d (41Bh) Elevator motor drive failed for initialization
1052d (41Ch) Elevator Motor voltage out of range
1053d (41Dh) Elevator move sequencer timed out
1054d (41Eh) Elevator not configured to unload a large cartridge
1055d (41Fh) Elevator not configured to unload a medium cartridge
1056d (420h) Elevator not configured to unload a small cartridge
1057d (421 Elevator servo failed to position for a move
1058d (422h) Elevator servo is not ready for auditing
1059d (423h) Elevator servo is not ready for loading
1060d (424h) Elevator servo is not ready for parking
1061d (452h) Elevator servo is not ready for unloading
1062d (426h) Elevator servo is not initialized
1063d (427h) Elevator size configuration is unknown
1064d (42h8) Elevator upper over travel limit exceeded
1065d (429h) Elevator upper over travel sensor tripped
1066d (42Ah) Elevator vane sensor data error
1067d (42Bh) Front door is open
1068d (42Ch) Front door must be closed for calibration
1069d (42Dh) Front door safety switch is open
1070d (42Eh) Front door safety switch was opened
1071d (42Fh) Illegal in-arm parameter
1072d (430h) In-arm audit move reported an illegal warning
1073d (43‘h) In-arm calibration data write checksum error
1074d (432h) In-arm failed to bumper position for unload
1075d (433h) In-arm failed to enable position mode after calibration
Table A-5. CHS Failure, Error, and Warning Codes (Continued)
CHS Code Description