User Guide

Ampex 1308904-X4 Preliminary Draft A-9
ACL Application Programmer’s Guide Vendor-Specific ACL Condition Codes
04h 55h BFh 3Fh
Hardware Error
CHS Hardware Failure
The CHS has been unable to
complete a request because of a
mechanical failure. The CHS Failure
additional sense page (0x83) will be
appended with the specific failure
code for the error.
Read Element Status and check
failure code returned.
04h 55h C1h 41h
Hardware Error
Internal Software Database Error
This is a hardware failure.
Contact Ampex Technical
Support.
05h 20h 00h 29h
Illegal Request
Unrecognized SCSI Command
Opcode
The SCSI command contained an
invalid opcode.
Re-issue the command with a
valid opcode.
05h 21h 01h 06h
Illegal Request
Invalid Element Address
The Move command cannot be
completed with the addresses(es)
supplied in the SCSI command.
Read Element Status and verify
that the addresses are valid and the
move is permitted.
05h 21h 01h 2Dh
Illegal Request
Cartridge ID in Move Volume
Command is Not in Database
The ACL does not contain the
cartridge you specified.
Load the cartridge into the ACL or
specify a different cartridge.
05h 21h 01h 32h
Illegal Request
Cartridge Barcode Cannot be Read
The ACL cannot read the barcode
label on the cartridge.
Replace the barcode label.
05h 21h 01h 33h
Illegal Request
Invalid Source Element Address
The move command cannot be
completed with the source address
supplied in the SCSI command.
Read Element Status and verify
that the addresses are valid and the
move is permitted.
05h 21h 01h 34h
Illegal Request
Invalid Destination Element Address
The move command cannot be
completed with the destination
address supplied in the SCSI
command.
Read Element Status and verify
that the addresses are valid and the
move is permitted.
Table A-4. Vendor-Specific ACL Condition Codes (Continued)
ACL
Sense ASC ASCQ Condition
Key Code
Condition Reported Recovery Procedure