User manual

Ampercell GmbH • Frankfurter Landstr. 68 • 61440 Oberursel -D • www.ampercell.com
EN Rechargeable COB LED Work Light AL 836
O p e r a t i n g i n s t r u c t i o n s
Technical features:
 Rechargeable cordless work light with 1x 3 Watt COB LED and 7 white LEDs in the lamp head
 Luminous flux: up to 200 lumens (at 100% brightness)
 Robust lamp body of ABS
 Soft touch surface
 Flexible lamp head, up to 180° swivelling
 3 switch modes: 30% and 100% COB LED – 7 LEDs – OFF
 Lighting time: up to 8 h with 1x 3W COB LED at 30% brightness, up to 2.5 h at 100% brightness
up to 12.5 h with 7 LEDs
 Rechargeable Li-Ion battery 3.7V – 2100mAh
 Rechargeable via 230V AC mains plug or 12V DC vehicle charger adaptor (included)
 Charging time: 4-5 hours
 Lighting range: 4 metres
 Strong magnets on the back and in the base of the lamp
 Practical, tiltable suspension hooks, rotatable by 360°
 With overloading and overdischarge protection
Instructions:
The Work Light AL 836 is equipped with the very latest LED technology called COB, or Chip on Board
LED. The main advantages of this technology are a longer lifetime and a higher light output from a
smaller area. What is more, this work light offers useful accessories for professional and private use,
like integrated, rotatable suspension hooks, a swivelling lamp head, and strong magnets at the rear
and in the lamp base to fix the light safely in a horizontal or vertical position on any metal surface.
The COB LED Work Light AL 836 offers three light sequences:
3 Watt COB LED (30% and 100% brightness) - 7 LEDs (in the lamp head) - OFF
Charging procedure:
You need to charge your COB LED Work Light AL 836 before you use it for the first time.
7. Make sure that your work light is switched off.
8. Connect the 230V AC mains plug or the 12V vehicle charger adaptor to the charging socket on the
rear of your work light. Connect the adaptor with a power source. During the charging process,
a red LED shines at the front of your work light to indicate charging, which will change to green
when the light is fully charged.
First charging will take approx. 5 to 6 hours.
9. When your light has been fully charged, disconnect the mains adaptor from the socket, or the
vehicle charger adaptor from the 12V vehicle connection, and then the plug from the charging
socket of your work light.
Safety advice:
 Do not shine directly into the eyes!
 Never immerse your work light in water or other fluids, not even for cleaning.
 Do not open your work light. It doesn’t contain any parts that need servicing.
 The LEDs and the battery are non-replaceable.
 If you don’t use your work light, charge the battery every two months.
 In case of improper use or wrong handling no liability will be accepted for possible damages.