User manual

SVT-7 PRO Bass Guitar Amplifier
SVT-7 PRO Bass Guitar Amplifier SVT-7 PRO Bass Guitar Amplifier
7
SPEAKER OUTPUTS TUBE DIRECT
OUTPUT
PRE-EQ
POST-EQ
AUX INPUT
(STEREO)
600 W @ 8Ω 1000W @ 4Ω MIN LOAD
SEND
FX
RETURNFOO T SW ITCH TUNER OUTPOWER AMP IN PREAMP OUT
P A TCH
FUSE T10AH 250V
LIFT
GND
-40dB
0dB
L
R
CLASS 2 WIRING
19. IEC POWER INPUT CONNECTOR: This
is where you connect the supplied AC
power cord.
Before plugging in the power cord, make
sure that the voltage selector switch is
set to the same voltage as your local AC
mains.
20. VOLTAGE SELECTOR SWITCH:
Make sure the switch is in the correct
position for your local AC mains voltage
before you plug in the AC power cord.
Use a small flat screwdriver to slide the
switch if required.
21. VENTILATION: Make sure that the
ventilation openings are not obscured in
any way. This will allow the flow of
cooling air to the power amplifier’s
heatsinks.
22. SPEAKER OUTPUTS: These Neutrik /
1/4" TS output jacks supply
speaker-level power to the speaker
cabinet. The rated power output is 600
watts rms into 8 ohms or 1000 watts
rms into 4 ohms.
The two identical outputs are wired in
parallel, and you can use either one, or
use both. Make sure the total speaker
impedance load is 4 ohms or greater.
For example, you could connect:
Two 16 ohm speakers (an 8 ohm load),
Two 8 ohm speakers (a 4 ohm load)
or one 4 ohm speaker.
Use speaker cables with Neutrik or 1/4"
TS ends to make the connections. Do
not use instrument cables as they may
overheat.
23. TUBE DIRECT OUTPUT: Typically, you
would connect this balanced output to
the balanced input of an external mixer,
or a recorder. In this way, you do not
have to mic the speaker cabinet in order
to add it to the main mix, or to record.
The output is not affected by the master
control.
This output can connect to external
power amplifiers, or powered
loudspeakers, as long as they have their
own input controls to adjust the volume
level.
Balanced connections allow long cable
runs to be used, as hum and noise
pickup in the line is minimized.
24. GROUND / LIFT: Press this switch in to
engage the Ground Lift, if necessary, to
help eliminate hum at the XLR jack.
25. 0dB (line level) / -40dB (mic level):
Press this switch in to apply a 40 dB cut
to the signal at the Tube Direct Output.
19 20 21 22 23 24
2930313233
25
26
27
28
The Rear Panel