SVT-7 PRO Bass Guitar Amplifier POWER MUTE INPUT PEAK MUTE COMPRESSION GAIN ULTRA HI BASS MIDRANGE FREQUENCY 1 2 3 4 5 TREBLE FX MIX MASTER ON THRESH 0 SIGNAL -15dB PHONES 10 0 10 0 10 0 10 0 10 DRY WET 0 ULTRA LO Owner’s Manual 10
SVT-7 PRO Bass Guitar Amplifier TABLE OF CONTENTS Introduction...........................................................................4 The Front Panel.....................................................................5 The Rear Panel......................................................................7 Favorite Settings....................................................................9 System Block Diagram.........................................................10 Technical Specifications..........
SVT-7 PRO Bass Guitar Amplifier NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
SVT-7 PRO Bass Guitar Amplifier Introduction Congratulations! You are now the proud owner of an Ampeg SVT-7 PRO bass guitar amplifier. This no-compromise amplifier packs 1000 watts of fury, a switching power supply and the classic good looks and features of our renowned SVT PRO Series amplifier head. The SVT-7 PRO amplifier is an ideal companion to the SVT-410HLF, SVT-610HLF, or SVT-810E cabinet, available separately.
SVT-7 PRO Bass Guitar Amplifier The Front Panel POWER MUTE INPUT PEAK MUTE COMPRESSION BASS MIDRANGE 10 3 45 0 10 1 2 3 4 5 TREBLE FX MIX MASTER PHONES 0 10 0 10 0 10 DRY WET 0 10 ULTRA LO 6 7 8 9 10 11 1. INPUT: The signal output from an instrument (active or passive) may be connected to this 1/4" input by means of a shielded instrument cable. 2.
SVT-7 PRO Bass Guitar Amplifier The Front Panel continued POWER MUTE INPUT PEAK MUTE COMPRESSION BASS MIDRANGE 10 3 45 0 10 1 2 3 4 5 TREBLE FX MIX MASTER PHONES 0 10 0 10 0 10 DRY WET 0 10 ULTRA LO 6 7 8 9 10 11 11. MIDRANGE: Use this to adjust the midrange frequency level of the amplifier. This provides up to 10 dB of boost, or 20 dB of cut at 800 Hz. The midrange frequency output is flat at the center position.
SVT-7 PRO Bass Guitar Amplifier The Rear Panel 33 32 FOOT SWITCH POWER AMP IN 31 30 PREAMP OUT RETURN PATCH SPEAKER OUTPUTS CLASS 2 WIRING 29 26 28 FX TUBE DIRECT OUTPUT SEND POST-EQ PRE-EQ 0dB -40dB FUSE T10AH 250V GND LIFT 600 W @ 8Ω 19 20 21 19. IEC POWER INPUT CONNECTOR: This is where you connect the supplied AC power cord. Before plugging in the power cord, make sure that the voltage selector switch is set to the same voltage as your local AC mains. 20.
SVT-7 PRO Bass Guitar Amplifier The Rear Panel continued 33 32 FOOT SWITCH POWER AMP IN 31 30 PREAMP OUT RETURN PATCH SPEAKER OUTPUTS CLASS 2 WIRING 29 26 28 FX TUBE DIRECT OUTPUT SEND POST-EQ PRE-EQ 0dB -40dB FUSE T10AH 250V GND LIFT 600 W @ 8Ω 19 20 21 TUNER OUT AUX INPUT (STEREO) L R 1000W @ 4Ω MIN LOAD 22 23 24 25 27 26. POST-EQ/PRE-EQ: The signal at the tube direct out can be set to either Pre-EQ or Post-EQ with this switch.
SVT-7 PRO Bass Guitar Amplifier Favorite Settings MUTE COMPRESSION 0 10 GAIN 0 10 -15dB MUTE COMPRESSION 0 10 GAIN 0 10 MIDRANGE 0 FREQUENCY 1 2 3 4 5 10 TREBLE 0 10 FX MIX DRY WET MASTER 0 10 ULTRA HI BASS 0 10 MIDRANGE 0 FREQUENCY 1 2 3 4 5 10 TREBLE 0 10 FX MIX DRY WET MASTER 0 10 ULTRA LO COMPRESSION 0 10 GAIN 0 ULTRA HI 10 BASS 0 10 MIDRANGE 0 FREQUENCY 1 2 3 4 5 10 TREBLE 0 10 FX MIX DRY WET MASTER 0 10 ULTRA LO COMPRESSION 0 -
SVT-7 PRO Bass Guitar Amplifier Block Diagram 10
SVT-7 PRO Bass Guitar Amplifier SVT-7 PRO TECHNICAL SPECIFICATIONS Output Power Rating 600 watts rms @ 8 ohms, 5% THD 1000 watts rms @ 4 ohms, 5% THD Signal to Noise Ratio 72 dB (20 Hz–20 kHz, unweighted) Maximum Gain 72 dB, tone controls centered Tone Controls Bass: +12/–12 dB @ 40 Hz Midrange: +10/–20 dB @ 220 Hz, 450 Hz, 800 Hz, 1.
FIG.$KMJ i\`]`cgd8 iXk`l> jjX9 PATCH FOOT SWITCH POWER AMP IN SPEAKER OUTPUTS CLASS 2 WIRING FX PREAMP OUT RETURN TUBE DIRECT OUTPUT SEND POST-EQ PRE-EQ 0dB -40dB FUSE T10AH 250V GND LIFT 600 W @ 8Ω 1000W @ 4Ω MIN LOAD launaM s’renwO TUNER OUT AUX INPUT (STEREO) L R
