User Manual

PF-115LF / PF-410HLF Speaker Cabinet

10" EMINENCE

8 OHM SPEAKERS

TWO

PARALLEL

JACKS

COMPRESSION

DRIVER

CROSS

OVER

Rear Panel Connector Plate

System Block Diagrams

1. 1/4" TS Full Range Input / Output Jacks:Thejackplatefeaturestwo1/4"jackswired

inparallel,allowingeasydaisy-chainingfromonespeakertoanother.Eachofthejacks

may be used as an input or a through connection.

 Connectthespeaker-leveloutputofyouramplifiertothecabinet’sinputjackusingagood

quality(non-shielded)speakercable.Never use (shielded) instrument cable to connect

speakers to an amplifier.

 Youcanutilizetheunusedjackasanoutput/throughjacktoconnectasecond8ohm

speakercabinetinparallel.Thiswillpresentatotalloadof4ohmstotheamplifier.

2. High Frequency Horn Level Switch [PF-410HLF only]:Thethree-positionHFHorn

switchallowsfor:

 •Fullhighfrequencyoutput(0setting)

 •Highfrequenciesreducedby6dB(–6setting)

 •Hornshutoff(offsetting)

PF-115LF

PF-410HLF

–

15" EMINENCE

8 OHM SPEAKER

TWO

PARALLEL

JACKS

PF-115LF

HIGH

FREQUENCY

ATTENUATOR

FULL RANGE

INPUTS

OFF

–6

IMPEDANCE: 8 OHMS

POWER: 800W RMS

PF-410HLF