User Guide

POWER:100WATTS
SPEAKER INPUT
8 OHM
MC 210E
17
Micro-CL Stack
6
The Rear Panel
12. AC POWER INPUT: The amplifier is
equipped with a detachable power cable
that plugs into the IEC Mains socket
on the back of the amplifier. The AC
power cord should only be plugged into
a grounded power outlet that meets all
applicable electrical codes and is
compatible with the voltage, power,
and frequency requirements stated
on the rear panel of the amplifier.
Do not attempt to defeat the safety
ground connection.
13. SPEAKER JACK: This 1/4" TS output
jack supplies speaker-level power to the
speaker cabinet [17]. The rated power
output is 100 watts into 8 ohms.
Use a speaker cable with 1/4" TS
ends to make the connections. Do
not use instrument cables as these
may overheat.
14. EFFECTS LOOP RETURN JACK: Use
this 1/4" TS unbalanced input to return
the processed line-level output of an
external effects processor (for example).
The processor could be fed by signals
from the effects loop send [15].
15. EFFECTS LOOP SEND JACK: Use this
1/4" TS unbalanced output to send a
line-level output to an external effects
processor (for example). The output
here is affected by all controls including
the master [3].
Use the loop return jack [14] to feed the
returned processed signals back into the
power amplifier.
16. UNBALANCED LINE OUT
JACK: Typically, you would connect
this output to the balanced input of
an external mixer, or a recorder. In
this way, you do not have to mic the
speaker cabinet in order to add it to
the main mix, or to record. The output
is not affected by the master control [3].
This output can connect to external
power amplifiers, or powered
loudspeakers, as long as they have
their own input controls to adjust the
volume level.
Rear Panel Connector Plate
17. 1/4" TS INPUT JACK: Connect the
speaker-level output [13] to this speaker
input jack using a (non-shielded) speaker
cable.
Never use a (shielded) instrument cable
to connect speakers to an amplifier.
OUTPUT POWER:
100WATTS @ 8 OHM
AC LINE IN
SPEAKER EFFECTS LOOP
RETURN SEND LINE OUT
SERIAL NO.
8 OHM
POWER SOURCE: 120V 60Hz
PRIMARY FUSE: T3AL /250V
POWER CONSUMPTION: 85W
CAUTION: TO PREVENT ELECTRIC SHOCK DO NOT REMOVE
CHASSIS (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE PERSONNEL.
AVIS: RISQUE DE CHOC ELECTRIQUE- NES PAS OUVRIR.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO
NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
ATTENTION: UTILISER UN FUSIBLE DE RECHANGE DE MEME TYPE.
MICRO CL
12 13 14 15 16