MICRO-CL STACK Owner’s Manual
Micro-CL Stack TABLE OF CONTENTS Important Safety Instructions............................................2 – 3 Introduction / Features...........................................................4 The Front Panel.....................................................................5 The Rear Panel / Rear Panel Connector Plate..........................6 Block Diagrams.....................................................................7 Technical Specifications / Service Information..........................
Micro-CL Stack NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Micro-CL Stack Introduction Let’s face it. You are the type who would happily crank up a full Ampeg SVT stack in your living room. Heck, who needs neighbors, anyway? And noise violations are really just a badge of honor, right? For the rest of us, there is the Ampeg Micro-CL stack, delivering 100 watts of Ampeg tone into any situation. It’s perfect for those just getting into Ampeg tone or for the seasoned bassist looking to practice in far flung locations like the master bathroom.
Micro-CL Stack The Front Panel MICRO CL 0dB 1 Input -15dB Master Treble Mid Bass Aux Level 2 3 4 5 6 7 1. 0dB INPUT: The signal output from a passive instrument may be connected to this 1/4" input by means of a shielded instrument cable. 2. –15dB INPUT: The signal output from an active instrument may be connected to this 1/4" input by means of a shielded instrument cable. 3. MASTER: Use this to control the output level of the instrument only.
Micro-CL Stack The Rear Panel MICRO CL AC LINE IN SPEAKER EFFECTS LOOP CAUTION: TO PREVENT ELECTRIC SHOCK DO NOT REMOVE CHASSIS (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. AVIS: RISQUE DE CHOC ELECTRIQUE- NES PAS OUVRIR. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. ATTENTION: UTILISER UN FUSIBLE DE RECHANGE DE MEME TYPE.
Micro-CL Stack System Block Diagrams Amplifier LINE OUT TONE CONTROL CIRCUITRY Inputs 0 dB Send -15 dB Treble Mid Bass Volume EFFECTS LOOP Return AUX Inputs POWER AMPLIFIER Aux Level Phones SPEAKER OUTPUT 100 W MUTE Cabinet Input (2) 10" speakers 7
Micro-CL Stack MICRO-CL TECHNICAL SPECIFICATIONS Output Power Rating 100 watts @ 8 ohms Signal to Noise Ratio 72 dB (20 Hz – 20 kHz, unweighted) Maximum Gain 59 dB at 1 kHz Amplifier Inputs 2 x 1/4" jacks [0dB, –15dB] 2 x 1/8" jacks [aux, headphones] Tone Controls Bass: +11/–11 dB @ 50 Hz Midrange: +11/–11 dB @ 600 Hz Treble: +13/–13 dB @ 6 kHz Power Requirements Japan 100V ~50–60 Hz, 85W U.S.
