Owner`s manual

MAX POWER INPUT 60 WATTS RMS
16 OHM PARALLEL JACKS
MODEL GVT112E_
MAX POWER INPUT 60 WATTS RMS
16 OHM PARALLEL JACKS
MODEL GVT112E_
MAX POWER INPUT 60 WATTS RMS
16 OHM PARALLEL JACKS
MODEL GVT112E_
MAX POWER INPUT 60 WATTS RMS
16 OHM PARALLEL JACKS
MODEL GVT112E_
EFFECTS LOOP
RETURN SEND
FOR 100-120 VAC, 50/60Hz: T1.6 AL250V FUSE
FOR 220-240VAC, 50/60Hz: T1 AL 250V FUSE
POWER CONSUMPTION 62W
POWER OUTPUT 15WATTS RMS - CONNECT SPEAKER BEFORE USE
4 OHMS
USE WITH ONE 4 OHM CABINET
OR TWO 8 OHM CABINETS
4 OHMS 8 OHMS 8 OHMS 16 OHMS
USE WITH ONE 8 OHM CABINET
OR TWO 16 OHM CABINETS
REVERB/EFFECTS
FOOT SWITCH
MODEL GVT15H
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES FOR THE U.S. AND ICES-003,
FOR CANADA. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS
DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED, INC LUDING INTERFERENCE THAT MAY
CAUSE UNDESIRED OPERATION.
WARNING:
DO NOT OBSTRUCT VENTILATION GRILLES
WARNING!
2 PREAMP: 12AX7/ECC83 /7025 2 POWER: 6V6TUBE COMPLEMENT
Guitar Speaker EnclosuresGVT112E / GVT112EW
6
™
This example shows how to daisy-chain multiple speaker enclosures. Connect one end of a speaker cable with
1/4" ends to the 4 Ω speaker output of the amplifier [Ampeg GVT15H shown] and the other end to the speaker
input of the first Ampeg GVT112E or GVT112EW speaker enclosure.
An additional speaker cable will connect to the remaining 1/4" jack of the first speaker enclosure and to the
input of the next speaker enclosure. Up to four Ampeg speaker enclosures may be daisy-chained together as
seen in the illustration above.
To reiterate: If more than one speaker is connected at the same time, make sure they all have the same
impedance rating. Never use two or more cabinets with different impedance ratings. This will create an
unbalanced load. When using multiple speaker cabinets (with the same impedance rating), match the total
load impedance of the speaker cabinets to the speaker output of the amplifier.
WARNING: Always use good quality (non-shielded) speaker cables. Never use (shielded) instrument cables to
connect speakers to an amplifier.
CELESTION VINTAGE 30
12" 16 Ω
Block Diagram
Hookup Diagrams continued...