User Manual

SVT-3 PRO Bass Guitar Amplifier SVT-3 PRO Bass Guitar Amplifier
7
The Front Panel continued
0
+12dB
-12dB
LEVEL
+8dB
-10dB
MUTE
EQ
PEAK /
MUTE
BRT
-15dB
HI
LO
zHk9zH33 5kHz2kHz900Hz600Hz300Hz150Hz80Hz
ON
POWER
ON
MASTER TUBE GAINTREBLEFREQUENCYMIDRANGEBASSGAININPUT
1 4 16 19 205 8 9 11 12 181713102 3 6 7 14 15
16. ACTIVE LED: This LED illuminates when
the EQ is on.
17. 9–BAND GRAPHIC EQ: These sliders
control the output frequencies indicated
above each control. The center position
of each control is flat [no boost or cut].
18. LEVEL: This slider is the output vol-
ume control for the Graphic EQ and
only affects the signal when the EQ is
engaged. If the EQ’d signal is too soft,
slide the level control up; if it’s too loud,
slide this control down.
19. ON LED: This LED illuminates when the
power is on.
20. POWER SWITCH: Use this switch to
turn the overall system power on or
off. Press the top of the switch to turn
on the power. Press the bottom of this
switch to put the amp into standby
mode. It will not function, but the circuits
are still live. To remove AC power, either
turn off the AC mains supply, or unplug
the power cord from the amplifier and
the AC mains supply.
NOTE: There is a delay during power up
until the protection relay enables the
power amplifier output.