User Manual

3
PF-115LF / PF-410HLF Speaker Cabinets
Rear Panel Connector Plate
PF-115LF PF-410HLF
1
PF-115LF
HIGH
FREQUENCY
ATTENUATOR
FULL RANGE
INPUTS
OFF
–6
0
IMPEDANCE: 8 OHMS
POWER: 800W RMS
PF-410HLF
12
1. 1/4" TS Full Range Input / Output Jacks: The jackplate features two 1/4" jacks wired
in parallel, allowing easy daisy-chaining from one cabinet to another. Each of the jacks
may be used either as an input or a through connection.
Connect the Speaker Output of your amplier to the cabinet’s Input jack using a
good quality (non-shielded) speaker cable. Never use (shielded) instrument cable
to connect speakers to an amplifier.
You can optionally utilize the unused jack as an output/through jack to connect a
second 8 Ω speaker cabinet in parallel. This will present a total load of 4 Ω to the
amplier.
2. High Frequency Horn Level Switch (PF-410HLF only) The 3-position HF Horn switch
allows for:
• Full high frequency output (0 setting)
• High frequencies reduced by 6 dB (–6 setting)
• Horn shuto (O setting)
System Block Diagrams
PF-115LF PF-410HLF
10" EMINENCE
8 OHM SPEAKERS
TWO
PARALLEL
JACKS
COMPRESSION
DRIVER
CROSS
OVER
–
15" EMINENCE
8 OHM SPEAKER
TWO
PARALLEL
JACKS
+