User Manual

5
Liquifier Analog Chorus
Rear and Bottom Panel Features
9
9. POWER CONNECTOR: This is where
to connect the optional power supply.
NOTE: Before plugging in the
power supply, make sure that
you are using the correct model power
supply for this product. Failure to do
so may result in damage to your unit
and void your warranty.
A DC-1G Power Supply may be
purchased from an Ampeg Dealer, or
you may purchase one directly from
the Ampeg Online Shop, at
shop.ampeg.com.
For residents outside of the US,
please request the model DC-1G
Power Supply when purchasing from
an Ampeg dealer or distributor in your
region.
BOTTOM PANEL ACCESS
This is where the 9V battery is housed.
Removing the bottom is easy. Simply
start by placing the pedal top down on
a soft, dry cloth.
Remove each of the four screws by
turning them counter-clockwise. Be
sure to keep them in a safe place as
you will need them again!
10. 9V BATTERY: The Liquier Analog
Chorus pedal may be powered by 9V
battery instead of using a power supply.
As seen in the illustration below, it ts
nicely inside a compartment of the
circuit board, next to the edge of the
pedal.
10
NOTE: Unplug the input cable when
not in use, as the 9V battery will drain
(and eventually die).
NOTE: When replacing the bottom of
the pedal, line up the rectangular foam
piece over the battery. Turn the screws
clockwise to ax to the bottom to the
pedal.