Owner’s Manual
Liquifier Analog Chorus TABLE OF CONTENTS Introduction ����������������������������������������������������������������������������������������������������������2 Features ����������������������������������������������������������������������������������������������������������������3 Top Panel Features ����������������������������������������������������������������������������������������������4 Rear and Bottom Panel Features ������������������������������������������������������������������������5 Sugge
Liquifier Analog Chorus Features • Dual chorus circuit design delivers incredibly rich chorus tones for both bass & guitar • Dial in the perfect sound with Rate, Depth, and Effect Level controls • True bypass, analog design with incredible signal-to-noise ratio • Roadworthy all-metal chassis construction • 9V DC supply or battery capable (not included) About the Liquifier Analog Chorus A chorus effect essentially copies the original signal, slightly alters the timing using delay, and combines it w
Liquifier Analog Chorus Top Panel Features 6. 4 5 Examples: • 9:00 – The swirling takes a subtle back seat to the dry signal. • 12:00 – With the Effect Level knob at half, the signal becomes a glorious 3-way psychedelic swirl. • 5:00 (100% wet) – This results in pure, through-zero flanging. 6 8 1 3 7 7. 2 8. 1. 2. 3. 4. 5. EFFECT LEVEL: Rotate this knob to adjust the overall effect level, from Dry (no effect, fully counter-clockwise) to Wet (100% effect, fully clockwise).
Liquifier Analog Chorus Rear and Bottom Panel Features Remove each of the four screws by turning them counter-clockwise. Be sure to keep them in a safe place as you will need them again! 10. 9V BATTERY: The Liquifier Analog Chorus pedal may be powered by 9V battery instead of using a power supply. As seen in the illustration below, it fits nicely inside a compartment of the circuit board, next to the edge of the pedal. 9 9. POWER CONNECTOR: This is where to connect the optional power supply.
Liquifier Analog Chorus Suggested Settings Believing (Don’t Stop) Nice & Easy Space Invaderz Nice Tremolo 6
Liquifier Analog Chorus Suggested Settings - Continued Hollow In & Out Inverted Warbly 7
INPUT LOW FREQUENCY OSCILLATOR HEAVY-DUTY FOOTSWITCH RATE CONTROL DEPTH CONTROL HI-Z JFET BUFFER INVERTER ANALOG DELAY LINES BBD BBD 8 TRUE-BYPASS SWITCHING PATH DELAY CLOCKS DRY AUDIO WET AUDIO EFFECT LEVEL MIXER CONTROL OUTPUT Liquifier Analog Chorus Block Diagram
Liquifier Analog Chorus Technical Specifications Signal-to-Noise Ratio 82 dB (Effect Level 100% Wet) 94 dB (Effect Level 100% Dry) Maximum Gain +0 dB (Unity) Maximum Input Level 1.1V RMS (3.0V peak-peak) before clipping (1.00% distortion), 100 Hz input Frequency Response (Input Level 1.00 V peak-peak) 100 Hz – 5 kHz, ±3.0 dB (100% Wet) 20 Hz – 20 kHz, ±0.
