User Guide

4
Front & Rear Panel Descriptions
1. 1/4" Inputs: Connect a passive or active instrument to the Input jack.
2. Pad: Reduces input level by 15 dB.
3. Volume: Adjusts the overall output level.
4. EQ Knobs: Boost or cut the levels at certain frequencies to enhance the sound.
5. Aux Level: Adjusts the Aux Input level.
6. Aux Input: Input for an MP3 player or other music source.
7. Headphones: Connect stereo headphones here.
8. Power Switch/Power LED: Turns the power on/off. The LED indicates power on/off (BA-108v2 and
BA-110v2 only).
9. Scrambler On/Off Switch: Turns the Scrambler on/off.
10. Scrambler Drive: Adjusts the amount of Drive.
11. Scrambler Blend: Blends the affected Scrambler signal with the clean bass signal.
12. Ultra Hi/Ultra Lo Switches: Boosts high or low frequencies.
13. Foot Switch Input: Turns the Scrambler on/off using an optional footswitch.
14. HF Mute: Mutes the high frequency driver.
15. Line Out: Feeds the signal to an external power amplifier, mixer or recording setup.
16. Effects Send Jack: Connect the input of an external FX processor.
17. Effects Return Jack: Connect the output of an external FX processor.
18. Speaker Output: 1/4" TS output jack for connecting an external 8
speaker cabinet.
Getting Started
1. Read and understand the included “Important Safety Instructions.”
2. Make sure the power switch is off before making any connections.
3. Push the included line cord securely into the amplifier’s IEC connector. Connect the line cord to a grounded
AC outlet. The amplifier may accept the appropriate voltage as indicated on the rear panel.
4. Connect an instrument to the Input jack with a 1/4" (shielded) instrument cable.
5. With all controls fully off, turn the amplifier on by flipping the power switch up.
6. While playing the instrument, adjust the volume knob to the preferred level.
7. Adjust the EQ knobs to taste.