THE AMPEG ADA6 DAN ARMSTRONG GUITAR Owner’s Manual
AMPEG DAN ARMSTRONG GUITAR Congratulations on your purchase of the Ampeg ADA6 Dan Armstrong Guitar! Your Ampeg instrument was manufactured to exacting specifications based on the original design introduced in 1969. Before shipment to your dealer, it was carefully inspected and put through a rigorous adjustment process by highly skilled technicians to ensure you the best possible sound and playability. This instrument is covered by Ampeg’s Five Year Warranty.
the pickup cavity. After mounting the new pickup, be sure to replace the rear thumb screw to insure correct electrical contact and pickup alignment. C o n t r o l s . The unique Ampeg Dan Armstrong Tone Control circuit offers incredible tonal flexibility from a single pickup unit. A 3-position switch is used to allow various “presets”. In the CENTER position, the TONE control is bypassed with the signal sent from the VOLUME control directly to the instrument output jack.
note is higher than the harmonic move that end of the bridge away from the fingerboard until the two notes are the same. If the note is lower than the harmonic, move the end of the bridge toward the fingerboard until the two notes are the same. Repeat this operation on the low “E” string, being careful to keep the treble side of the bridge in place. R e g i s t e r . It only takes a couple of minutes to sign up for five years peace of mind. Go to www.ampeg.com/reg and register your guitar today.
