User's Manual

- 43 -
WLAN Broadband Router
User Manual
Connection Type
Select the connection type from pull-down menu. There
are Continuous, Connect on Demand and Manual
three types to select.
Continuous connection type means to setup the
connection through PPPoE protocol whenever this
WLAN AP Router is powered on.
Connect on Demand connection type means to setup
the connection through PPPoE protocol whenever you
send the data packets out through the WAN interface;
there are a watchdog implemented to close the PPPoE
connection while there are no data sent out longer than
the idle time set.
Manual connection type means to setup the connection
through the PPPoE protocol by clicking the Connect
button manually, and clicking the Disconnect button
manually.
Idle Time
If you select the PPPoE and Connect on Demand
connection type, fill in the idle time for auto-disconnect
function. Value can be between 1 and 1000 minutes.
MTU Size
Fill in the MTU size of MTU Size.
Attain DNS Automatically
Click to select getting DNS address for DHCP support.
Please select Set DNS Manually if the DHCP support is
selected.
Set DNS Manually
Click to select getting DNS address for DHCP support.
DNS 1~3
Fill in the IP address of Domain Name Server 1~3.
Clone MAC Address
Fill in the MAC address that is the MAC address to be
cloned.
Enable uPNP
Click the checkbox to enable uPNP function.
Enable IGMP Proxy
Click the checkbox to enable IGMP Proxy.
Enable Ping Access on WAN
Click the checkbox to enable WAN ICMP response.
Enable Web Server Access on WAN
Click the checkbox to enable web configuration from
WAN side.
Enable IPsec pass through on VPN connection
Click the checkbox to enable IPSec packet pass through.
Enable PPTP pass through on VPN connection
Click the checkbox to enable PPTP packet pass through.
Enable L2TP pass through on VPN connection
Click the checkbox to enable L2TP packet pass through.
Apply Changes
Click the Apply Changes button to complete the new
configuration setting.
Reset
Click the Reset button to abort change and recover the
previous configuration setting.