User's Manual

- 30 -
WLAN Broadband Router
User Manual
4.3.3.5 WDS Settings
Wireless Distribution System uses wireless media to communicate with other APs, like the Ethernet
does. To do this, you must set these APs in the same channel and set MAC address of other AP that you
want to communicate with in the table and then enable the WDS.
Item Description
Enable WDS Click the check box to enable wireless distribution system.
MAC Address Fill in the MAC address of AP to register the wireless distribution system
access capability.
Data Rate Select the transmission data rate from pull-down menu. Data rate can be
auto-select, 1M to 54Mbps or MCS.
Comment Fill in the comment tag for the registered AP.
Apply Changes Click the Apply Changes button to complete the new configuration setting.
Reset
Click the Reset button to abort change and recover the previous
configuration setting.
Set Security
Click button to configure wireless security like WEP(64bits),
WEP(128bits), WPA(TKIP), WPA2(AES) or None
Show Statistics It shows the TX, RX packets, rate statistics.
Delete Selected
Click to delete the selected clients that will be access right removed from
this WLAN Broadband Router.
Delete All Click to delete all the registered clients from the access allowed list.
Reset
Click the Reset button to abort change and recover the previous
configuration setting.