User's Manual
Table Of Contents
- INTRODUCTION
- GETTING STARTED
- SETUP GUIDE
- 5.0GHz WI-FI SETTINGS
- 5.0GHz Wi-Fi Settings: Home Network Settings (5.0GHz)
- 5.0GHz Wi-Fi Settings: Extended Network Settings (5.0GHz)
- 5.0GHz Wi-Fi Settings: Security (5.0GHz)
- 5.0GHz Wi-Fi Settings: Wi-Fi Protected Setup – WPS (5.0GHz)
- 5.0GHz Wi-Fi Settings: User Access (5.0GHz)
- 5.0GHz Wi-Fi Settings: Wireless Coverage Controls (5.0GHz)
- 5.0GHz Wi-Fi Settings: Access Schedule (5.0GHz)
- 5.0GHz Wi-Fi Settings: Advanced Settings (5.0GHz)
- 2.4GHz WI-FI SETTINGS
- 2.4GHz Wi-Fi Settings: Home Network Settings (2.4GHz)
- 2.4GHz Wi-Fi Settings: Extended Network Settings (2.4GHz)
- 2.4GHz Wi-Fi Settings: Wi-Fi Protected Setup – WPS (2.4GHz)
- 2.4GHz Wi-Fi Settings: User Access (2.4GHz)
- 2.4GHz Wi-Fi Settings: Wireless Coverage Controls (2.4GHz)
- 2.4GHz Wi-Fi Settings: Access Schedule (2.4GHz)
- 2.4GHz Wi-Fi Settings: Advanced Settings (2.4GHz)
- USB STORAGE
- NETWORK SETTINGS
- MANAGEMENT FEATURES
- TECHNICAL SPECIFICATIONS
- DEFAULT SETTINGS
- TROUBLESHOOTING AND SUPPORT INFORMATION
SR20000G
USER’S GUIDE
60
Troubleshooting: Home Network Connection Issues
I cannot connect to my Home Network. I received an error when running the Smart Setup Wizard.
a. Your Home Network may be secured. Double check that you have the correct security key to connect
to the Home Network.
b. Your Dual Band Repeater may be located too far from your Home Network. Run through the Setup
Wizard again. On the SCAN page, your Home Network should show a signal strength of 70% or
greater. If it does not, move the Dual Band Repeater closer to your Home Network and try again.
c. If you are connecting to a dual band router, both networks (2.4GHz and 5.0GHz) should have a signal
strength of 70% or greater.
d. Check to see that your Home Network router’s DHCP server is enabled. The Dual Band Repeater
needs to obtain an IP from your Home Network router.
I cannot find my Home Network when scanning for wireless networks in the Smart Setup Wizard.
a. The Dual Band Repeater may be out of range. Move the Dual Band Repeater closer towards the
wireless router and try the Setup Wizard again from the Web Menu. It is recommended that your
Home Network shows a signal strength of 70% or greater in the Smart Setup Wizard SCAN results.