User's Manual
Table Of Contents
- INTRODUCTION
- GETTING STARTED
- SETUP GUIDE
- 5.0GHz WI-FI SETTINGS
- 5.0GHz Wi-Fi Settings: Home Network Settings (5.0GHz)
- 5.0GHz Wi-Fi Settings: Extended Network Settings (5.0GHz)
- 5.0GHz Wi-Fi Settings: Security (5.0GHz)
- 5.0GHz Wi-Fi Settings: Wi-Fi Protected Setup – WPS (5.0GHz)
- 5.0GHz Wi-Fi Settings: User Access (5.0GHz)
- 5.0GHz Wi-Fi Settings: Wireless Coverage Controls (5.0GHz)
- 5.0GHz Wi-Fi Settings: Access Schedule (5.0GHz)
- 5.0GHz Wi-Fi Settings: Advanced Settings (5.0GHz)
- 2.4GHz WI-FI SETTINGS
- 2.4GHz Wi-Fi Settings: Home Network Settings (2.4GHz)
- 2.4GHz Wi-Fi Settings: Extended Network Settings (2.4GHz)
- 2.4GHz Wi-Fi Settings: Wi-Fi Protected Setup – WPS (2.4GHz)
- 2.4GHz Wi-Fi Settings: User Access (2.4GHz)
- 2.4GHz Wi-Fi Settings: Wireless Coverage Controls (2.4GHz)
- 2.4GHz Wi-Fi Settings: Access Schedule (2.4GHz)
- 2.4GHz Wi-Fi Settings: Advanced Settings (2.4GHz)
- USB STORAGE
- NETWORK SETTINGS
- MANAGEMENT FEATURES
- TECHNICAL SPECIFICATIONS
- DEFAULT SETTINGS
- TROUBLESHOOTING AND SUPPORT INFORMATION
SR20000G
USER’S GUIDE
57
Troubleshooting
The tips in this guide are listed in order of relevance. Try solution (a) before trying solution (b), etc.
Troubleshooting: Web Menu Access Issues
I entered http://setup.ampedwireless.com and it failed to open the Web Menu.
a. Make sure your computer is connected to the Dual Band Repeater using the included Ethernet cable.
Do not try to connect with a wireless connection. Ensure that the power on the Dual Band Repeater is on.
b. Make sure your computer is NOT connected to any wireless networks. If it is, disconnect and try again.
c. Try to use a different web browser. We recommend the Google Chrome web browser.
d. Try to open your web browser to the default IP address by putting this number into your web browser
instead: 192.168.1.240
e. Power off (unplug the power adapter) the Dual Band Repeater and power it back on. Try again.
f. Reset your Dual Band Repeater to default settings by holding the Reset Button (located on the back
panel) for ten (10) seconds and try again.