User's Manual
Table Of Contents
- INTRODUCTION
- GETTING STARTED
- SETUP GUIDE
- 5.0GHz WI-FI SETTINGS
- 5.0GHz Wi-Fi Settings: Home Network Settings (5.0GHz)
- 5.0GHz Wi-Fi Settings: Extended Network Settings (5.0GHz)
- 5.0GHz Wi-Fi Settings: Security (5.0GHz)
- 5.0GHz Wi-Fi Settings: Wi-Fi Protected Setup – WPS (5.0GHz)
- 5.0GHz Wi-Fi Settings: User Access (5.0GHz)
- 5.0GHz Wi-Fi Settings: Wireless Coverage Controls (5.0GHz)
- 5.0GHz Wi-Fi Settings: Access Schedule (5.0GHz)
- 5.0GHz Wi-Fi Settings: Advanced Settings (5.0GHz)
- 2.4GHz WI-FI SETTINGS
- 2.4GHz Wi-Fi Settings: Home Network Settings (2.4GHz)
- 2.4GHz Wi-Fi Settings: Extended Network Settings (2.4GHz)
- 2.4GHz Wi-Fi Settings: Wi-Fi Protected Setup – WPS (2.4GHz)
- 2.4GHz Wi-Fi Settings: User Access (2.4GHz)
- 2.4GHz Wi-Fi Settings: Wireless Coverage Controls (2.4GHz)
- 2.4GHz Wi-Fi Settings: Access Schedule (2.4GHz)
- 2.4GHz Wi-Fi Settings: Advanced Settings (2.4GHz)
- USB STORAGE
- NETWORK SETTINGS
- MANAGEMENT FEATURES
- TECHNICAL SPECIFICATIONS
- DEFAULT SETTINGS
- TROUBLESHOOTING AND SUPPORT INFORMATION
SR20000G
USER’S GUIDE
47
Connection State: The Connection State will say "Connected" when there are no problems with the connection
to your Home Network.
If the Connection State shows "Waiting for Keys" then the WPA/WPA2 security key you entered is incorrect.
If the Connection State shows "Scanning" the Dual Band Repeater may be too far away from your home/office
router.
The Signal Strength display can be updated by refreshing the page and is a good tool to use for finding the
optimal installation location. A signal strength of 70% or greater is recommended for stable operation of the
High Power Dual Band Repeater.
Extended Wireless Network Settings: Shows the current settings for your Extended Wireless Network (2.4GHz
or 5.0GHz).
IP Settings: The network IP settings for your High Power Dual Band Repeater will change as you connect and
disconnect from your 2.4 or 5.0GHz Home Network. When connected to your Home Network, the network IP
settings will be assigned by your Home Network. When not connected, the High Power Dual Band Repeater
will use its own default network IP settings. These IPs are assigned to the 2.4 and 5.0GHz networks
individually.