User's Manual
Table Of Contents
- INTRODUCTION
- GETTING STARTED
- SETUP GUIDE
- 5.0GHz WI-FI SETTINGS
- 5.0GHz Wi-Fi Settings: Home Network Settings (5.0GHz)
- 5.0GHz Wi-Fi Settings: Extended Network Settings (5.0GHz)
- 5.0GHz Wi-Fi Settings: Security (5.0GHz)
- 5.0GHz Wi-Fi Settings: Wi-Fi Protected Setup – WPS (5.0GHz)
- 5.0GHz Wi-Fi Settings: User Access (5.0GHz)
- 5.0GHz Wi-Fi Settings: Wireless Coverage Controls (5.0GHz)
- 5.0GHz Wi-Fi Settings: Access Schedule (5.0GHz)
- 5.0GHz Wi-Fi Settings: Advanced Settings (5.0GHz)
- 2.4GHz WI-FI SETTINGS
- 2.4GHz Wi-Fi Settings: Home Network Settings (2.4GHz)
- 2.4GHz Wi-Fi Settings: Extended Network Settings (2.4GHz)
- 2.4GHz Wi-Fi Settings: Wi-Fi Protected Setup – WPS (2.4GHz)
- 2.4GHz Wi-Fi Settings: User Access (2.4GHz)
- 2.4GHz Wi-Fi Settings: Wireless Coverage Controls (2.4GHz)
- 2.4GHz Wi-Fi Settings: Access Schedule (2.4GHz)
- 2.4GHz Wi-Fi Settings: Advanced Settings (2.4GHz)
- USB STORAGE
- NETWORK SETTINGS
- MANAGEMENT FEATURES
- TECHNICAL SPECIFICATIONS
- DEFAULT SETTINGS
- TROUBLESHOOTING AND SUPPORT INFORMATION
SR20000G
USER’S GUIDE
41
Mac OS X
To access the drive from your Mac desktop:
Note: If the USB drive does not appear automatically under your Networked devices, you will need to Map your Network Drive
(Instructions below).
a. Open Finder
b. On the left hand menu, under Shared, click AMPED_REP_USB
To Map the network drive:
a. Open Finder
b. From the menu on the top of the desktop, select Go
c. Select Connect To Server from the drop down menu
d. Enter the address of the network drive:
smb://AMPED_REP_USB/public or smb://repeater’s LAN ip address/public
Then click Connect
If the network drive does not appear on your Mac desktop, follow these steps:
a. Open Finder
b. Select Preferences from the drop down menu
c. Check show "Connected Servers"
d. The drive should now appear on your desktop