User`s guide

SR20000G
USER’S GUIDE
62
c. The Dual Band Repeater may be too far from your home router and not maintaining a signal strength
of above 70%. Check the signal strength between the router and the Dual Band Repeater through the
web menu (left side): More Settings > Management > Repeater Status. The Signal Strength readout
will be under the Home Wireless Network Settings section. This Signal Strength must be above 70%. If
it is below, move the Dual Band Repeater closer to your router, or reposition the Dual Band Repeater.
d. Rescan for another network by accessing http://setup.ampedwireless.comto connect to and repeat or
you may try to fix the issues with your Home Network and your home wireless router.
e.
Check to see that your home wireless router settings have not changed. Any changes to the SSID,
security, or channel number from the original settings will disconnect the Dual Band Repeater’s
connection to the home network To solve this simply run the Smart Setup Wizard again from the web
menu and reconfigure your Home Network connection. You can also set a static channel number on
your router to prevent this from happening again in the future.
f. If you cannot access the setup menu, check to see that your Dual Band Repeater is still on. Reboot the
Dual Band Repeater by unplugging the power adapter and plugging it back in. Check to see if your
connection has been reestablished by viewing a website. If you do not have a connection, logon
to http://setup.ampedwireless.com
and configure a new Home Network connection.
g. Check to see that your home wireless router is still on. If it has been turned off please turn it back on.
The Dual Band Repeater should automatically reconnect to your Home Network within 10 minutes.