User`s guide

SR20000G
USER’S GUIDE
63
63
c. The Range Extender may be too far from your home router and not maintaining a signal strength of
above 70%. Check the signal strength between the router and the Range Extender through the web
menu (left side): More Settings > Management > Device Status. The Signal Strength readout will be
under the Home Wireless Network Settings section. This Signal Strength must be above 70%. If it is
below, move the Range Extender closer to your router, or reposition the Range Extender.
d. Rescan for another network by accessing http://setup.ampedwireless.comto connect to and repeat or
you may try to fix the issues with your Home Network and your home wireless router.
e. Check to see that your home wireless router settings have not changed. Any changes to the SSID,
security, or channel number from the original settings will disconnect the Range Extender’s connection
to the home network To solve this simply run the Setup Wizard again from the web menu and
reconfigure your Home Network connection. You can also set a static channel number on your router
to prevent this from happening again in the future.
f. If you cannot access the setup menu, check to see that your Range Extender is still on. Reboot the Range
Extender by unplugging the power adapter and plugging it back in. Check to see if your connection has
been reestablished by viewing a website. If you do not have a connection, logon to
http://setup.ampedwireless.com and configure a new Home Network connection.
g. Check to see that your home wireless router is still on. If it has been turned off please turn it back on.
The Range Extender should automatically reconnect to your Home Network within 10 minutes.