Installation Instructions

ManualsBrandsAmpcaddy ManualsAudio EquipmentV3 PRO MAX WEATHERPROOF WIRELESS SPEAKER

2 3

5 6

8 9

Short press to turn on. Press 2 times to pair multiple speakers

Long press for 3 seconds to turn off

Micro SD Card must be equal to or less than 64GB

1. Blue LED light blinks when the speaker is waiting to pair to a device. It will change to solid blue after

successfully pairing with device.

2. Red LED light is solid red when the speaker is recharging. It will turn off when the battery is fully charged.

3. Yellow LED light blinks when pairing multiple speakers. When you’ve successfully matched the two speakers,

the Yellow LED light will become solid.

Pairing one speaker to your device

· Long press the power button. The speaker will automatically go into pairing mode

· Go to the Bluetooth Settings on your device and select “Ampcaddy”

· Success

Pairing two speakers together

· Verify both speakers are disconnected from your device before the speakers are turned on

· Turn on Ampcaddy Bluetooth speaker

· Press the TWS pairing button for 2 seconds, you will hear a double beep and the yellow light

will blink

· Press the TWS pairing button for 2 seconds on the second Ampcaddy speaker, you will hear a

double beep and the yellow light will flash, yellow light will turn solid when TWS pairing

has completed.

· Go to Bluetooth settings on your device and select Ampcaddy

· Success! Ampcaddy speakers will now perform in stereo sound

· Once the speakers have been paired successfully, they will automatically pair at each

subsequent use

. While in

Long

20x2 (40W total)

Press once when music is playing to pause, answer incoming calls or to hang up a phone call

Press and hold for 2 seconds to reject the incoming call

Short press this button to decrease the volume

Long press 2 seconds to skip track.

Short press this button to increase the volumeLong press 2 seconds to skip track.

FCC Warning

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not

cause harmful interference, and (2) this device must accept any interference received, including interference that may cause

undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to

operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the

FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a

particular installation.

If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more

of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition

without restriction.

3.7V/6600mAh