User's Manual

AMPAK Technology Inc. www.ampak.com.tw Proprietary & Confidential Information
Doc. NO:
5
4. Starting the Application BToll
On Start-up you should be able to set the Serial Port Settings. Set the “Port” value to the
COM port earlier noted in Section 3. Baud rate select 115200. For the other settings, use the
default values as shown in Figure 8. Press “OK” to connect to the Host Board
Figure 8 BTool, Serial Port settings
When connected you should see the screen presented in Figure 9. The screen indicates that
you now have a serial port connection to the MWCT-759B Board.